Инструкция для GIGABYTE GA-H55M-S2H (REV. 1.1), GA-H55M-D2H (REV. 1.4)

(скачивание инструкции бесплатно)
Формат файла: PDF
Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.
Дополнительно: Чтение инструкции онлайн
background image

- 20 -

Hardware Installation

  Optical S/PDIF Out Connector

 

This connector provides digital audio out to an external audio system that supports digital optical audio.  

 

Before using this feature, ensure that your audio system provides an optical digital audio in connector.

  RJ-45 LAN Port

 

The Gigabit Ethernet LAN port provides Internet connection at up to 1 Gbps data rate. The following de-
scribes the states of the LAN port LEDs.

Activity LED:

State  

Description

Blinking  Data transmission or receiving is occurring
Off   

No data transmission or receiving is occurring

Connection/Speed LED:

State  

Description

Orange  

1 Gbps data rate

Green  

100 Mbps data rate

Off   

10 Mbps data rate

Activity LED

Connection/

Speed LED 

LAN Port

  Center/Subwoofer Speaker Out Jack (Orange)

 

Use this audio jack to connect center/subwoofer speakers in a 5.1/7.1-channel audio configuration.

  Rear Speaker Out Jack (Black)

 

Use this audio jack to connect rear speakers in a 4/5.1/7.1-channel audio configuration.

  Side Speaker Out Jack (Gray)

 

Use this audio jack to connect side speakers in a 7.1-channel audio configuration.

  Line In Jack (Blue)

 

The default line in jack. Use this audio jack for line in devices such as an optical drive, walkman, etc.

  Line Out Jack (Green)

 

The default line out jack. Use this audio jack for a headphone or 2-channel speaker. This jack can be 
used to connect front speakers in a 4/5.1/7.1-channel audio configuration.

  Mic In Jack (Pink)

 

The default Mic in jack. Microphones must be connected to this jack.

In addition to the default speakers settings, the ~

 

audio jacks can be reconfigured to per-

form different functions via the audio software. Only microphones still MUST be connected to 
the default Mic in jack ( ). Refer to the instructions on setting up a 2/4/5.1/7.1-channel audio 
configuration in Chapter 5, "Configuring 2/4/5.1/7.1-Channel Audio."

•  When removing the cable connected to a back panel connector, first remove the cable from 

your device and then remove it from the motherboard. 

•  When removing the cable, pull it straight out from the connector. Do not rock it side to side to 

prevent an electrical short inside the cable connector. 

Dual Display Configurations for the Onboard Graphics:

 

The table below shows the supported/unsupported dual display configurations for the onboard graphics  

 

ports in different environments. 

  Combination 

   POST/BIOS 

Windows

  DVI-D + D-Sub   

Yes 

  Yes

  DVI-D + HDMI   

No 

  Yes

  HDMI + D-Sub   

Yes 

  Yes

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
Оглавление инструкции

Document Outline