Инструкция для MITSUBISHI ELECTRIC LGH-80RX4-E, LGH-80RX3-E, LGH-65RX4-E, LGH-50RX4-E, LGH-50RX3-E, LGH-35RX4-E, LGH-35RX3-E, LGH-25RX4-E, LGH-25RX3-E, LGH-200RX4-E, LGH-200RX3-E, LGH-15RX4-E, LGH-15RX3-E, LGH-150RX4-E, LGH-150RX3-E, LGH-100RX4-E, LGH-100RX3-E

(скачивание инструкции бесплатно)
Формат файла: PDF
Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.
Дополнительно: Чтение инструкции онлайн
background image
1
2
3
4
5
6
7
8
9
10
11
12
Оглавление инструкции
  • Страница 1 из 13
  • Страница 2 из 13
  • Страница 3 из 13
  • Страница 4 из 13
  • Страница 5 из 13
  • Страница 6 из 13
  • Страница 7 из 13
  • Страница 8 из 13
    14. Lossnay M-NET Remote Controller (PZ-52SF-E) 14.1 Operation [CENTRAL] Display [INTERLOCKED] Display Displayed when remote operation is prohibited by a centralised control unit, etc. Displayed when the Lossnay unit starts due to interlocked indoor unit or external signal. [Fan speed] Display
  • Страница 9 из 13
    14.2 Installing the Lossnay M-NET Remote Controller 14.2.1 Mount the switch box. Switch box Projecting object such as a stud Outline of Lossnay remote controller 40 mm or more 1. Install the switch box (purchased separately) as explained below. Note: ● Be sure to install the switch box with the
  • Страница 10 из 13
    901 23 78 901 23 456 SW2 456 SW1 78 Rotary switches 5. Set the Lossnay M-NET remote controller address. Set the Lossnay M-NET remote controller address using the rotary switches SW1 and SW2 on the front of the Lossnay M-NET remote controller. ■ Setting range: 101 to 200 ● Rotary switch SW1
  • Страница 11 из 13
    14.3 Registering the Lossnay Unit with the Lossnay M-NET Remote Controller Initial registration mode operation A Lossnay unit must be registered with the Lossnay M-NET remote controller in a group arrangement. Register a Lossnay unit using the initial registration mode as shown below. In addition,
  • Страница 12 из 13
    Confirmation of registered address 6 To display the addresses of the Lossnay units that are registered with this Lossnay M-NET remote controller. Each press of FILTER in step 2 or 4 displays the address of a registered Lossnay unit and its type, “LC”. If no Lossnay unit is registered, “ ---”
  • Страница 13 из 13