Инструкция для ARCAM DiVA A70

(скачивание инструкции бесплатно)
Формат файла: PDF
Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.
Дополнительно: Чтение инструкции онлайн
background image

A70

H A N D B O O K / M A N U E L / H A N D B U C H / H A N D L E I D I N G

English

Français

Deutsch

Arcam A70 amplifier
Amplificateur Arcam A70
Arcam-Verstärker A70
Arcam-versterker A70

Nederlands

1
2
3
4
5
6
7
8
9
10
11
12
Оглавление инструкции
  • Страница 1 из 13
    HANDBOOK/MANUEL/HANDBUCH/HANDLEIDING Arcam A70 amplifier A70 English Amplificateur Arcam A70 Français Arcam-Verstärker A70 Deutsch Arcam-versterker A70 N ederlands
  • Страница 2 из 13
    Safety guidelines CAUTION ATTENTION RISK OF ELECTRIC SHOCK DO NOT OPEN RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR CAUTION: To reduce the risk of electric shock, do not remove cover (or back). No user serviceable parts inside. Refer servicing to qualified service personnel. WARNING: To reduce the risk
  • Страница 3 из 13
    Using this handbook Your amplifier may have been installed and set up by an authorised Arcam dealer. In this case, you may wish to go directly to the sections describing the use of this equipment. Safety Safety guidelines are set out on the inside front cover of this handbook. Many of these items
  • Страница 4 из 13
    Installation Positioning the unit Place your amplifier on a level, firm surface. Avoid placing the unit in direct sunlight or near sources of heat or damp. Ensure adequate ventilation. Do not place the unit in an enclosed space such as a bookcase or cabinet as both of these will impede air flow
  • Страница 5 из 13
    Standby power For remote standby operation, the amplifier’s control power supply is kept powered up all the time the unit is connected to the mains supply. The front panel power switch powers down all other circuitry. Power consumption in this mode is less than 2.5W. E nglish This means that even
  • Страница 6 из 13
    Using your A70 amplifier � � � � � �� � � Front panel controls This section describes how to operate your amplifier. If you are installing the amplifier yourself, you should first read the ‘Installation’ section on page 4. POWER (and power indicator light) bk Switches the unit on and off. (You can
  • Страница 7 из 13
    Recording With the Arcam A70 it is possible to listen and to record from one source, or to listen to one source while recording another. The record signal is sent to the TAPE output sockets. These sockets are suitable for use with almost any type of recorder (cassette, CDR, MD, VCR, reel-to-reel,
  • Страница 8 из 13
    Setting up your A70 amplifier The A70 allows you to adjust listening settings to suit your taste, and to customise various features of the amplifier to fit your system. Use this diagram to help you navigate through the settings available. The ENTER and SELECT buttons are represented in the diagram
  • Страница 9 из 13
    Using the remote control CR-389 Remote Control E nglish The CR-389 remote control gives access to all functions available on the front panel of the A70. It also has controls to operate Arcam CD players, AM/FM tuners and DAB tuners. The remote control transmits Philips RC-5 type codes. TUNER These
  • Страница 10 из 13
    Bi-wiring and bi-amping loudspeakers Before you start Bi-amping your system WARNING: Do not make any connections to your amplifier while it is switched on or connected to the mains supply. Before switching on please check all connections thoroughly, making sure bare wires or cables are not touching
  • Страница 11 из 13
    Service information Sound cuts out unexpectedly E nglish Before returning an amplifier for repair, please check the following: Heatsink protection If the temperature of the internal heatsink rises above a safe level, a thermal cutout inside the amplifier operates, the power indicator on the front
  • Страница 12 из 13
    Remote-control codes The following table gives the IR-commands accepted by the A70. Power commands Menu navigation commands Command Decimal Code Select 16–37 Enter 16–87 Command Decimal Code Power toggle 16–12 Power-on 16–123 Speaker control commands Power-off 16–124 Command Decimal Code Speaker 1
  • Страница 13 из 13