I.   PRODUCT DESCRIPTIONS

Thank you for using our company the BS1501DMX, it is a powerful DMX
strobe that allows control flash speed and dimmer, and it has two operating
mode  by  changing  DIP  switch  setting:  DMX  self-test  mode  and  DMX  pack
mode . Prior to use, we suggest that you carefully read all of the instructions.
By following the instructions found in these operations, you can look forward
to reliable and satisfactory performance of your BS1501DMX for years to
come.

II

．

TECHNICAL SPECIFICATIONS

Power Input

:

AC 240V, 50Hz, 16A max.

Flash Tube

:

1500W, 5x10

6

life

Circuit Breaker

:

16A

DMX In/Out

:

3 pin female & male XLR socket x 1

Dimensions

:

L453xW136xH207 mm

Weight

:

5.6Kgs

III

．

REAR FUNCTIONS

1.

Power Input:

AC 240V, 60/50Hz, 16A max.

2.

Circuit breaker:

16A.

3.

Power Indicator:

Indicator when power is on.

4.

DMX DIP switch:

Assign  DIP  switch  10  to  ON,the  unit  is  in  DMX  pack

mode.Follow DMX addressing printed on the rear for desired speed and
dimming settings. Assign DIP switch 10 to OFF,   the unit is in DMX self-test
mode , follow self-test settings to select desired chase.

5.

DMX Indicator:

Indicator when DMX is effective.

6.

DMX Signal Output:

XLR female socket,use to connect other strobe.

7.

DMX Signal Input:

XLR male socket,use to receive DMX signal.

123

45

67

89

10

Page  3

IV

．

OPERATION INSTRUCTIONS

1.

Please confirm power input is matched with that specified on this unit.

2.

Plug in power cord to turn the power on.

3.

This unit has two operating modes:DMX self-test mode and DMX pack mode.

4.

Switch DIP switch 10 to OFF position,this unit is in DMX self-test
mode.There are two self-test modes:AUTO and MANUAL.Set DIP switch 9 to
OFF,it performs AUTO self-test.When strobe flashes within the dimming
range from 0% to 100% and then from 100% to 0%,a slower or faster speed
will be executed.This strobe will flash with the regular speed corresponding to
the variety of the duration of dimmer.Set DIP switch 9 to ON, it performs
MANUAL self-test.DIPswitch 1,2,3 and 4 are assigned to control speed,and
DIP switch 5,6,7 and 8 are assigned to adjust dimming level.

5.

Switch DIP switch 10 to ON position,this unit is in DMX pack mode.Follow
DMX address setting printed on the rear for desired flash speed and dimmer.

6.

For safety,disconnect power cable when not using.

V.  WARNING

1.

Avoid direct eye exposure.

2.

Disconnect from main power before replacing lamps or servicing unit.