I Technical Specifications:
Item Code: UV PRO400
Name: PROJECTION LIGHT
Voltage: AC 24V, 50Hz
Bulb: 240V 400W E40 MERCURIC BULB
Fuse: 250V/5A
Weight: 8.0kg
Size: L440 x W295 x H170mm
II Operational Instructions:
1. Unpack the carton to check if there is any damaged or missing
parts when you receive the unit, call the local dealer if anything
is found not in a normal condition.
2. Open the cover and install the lamp. Keep the lamp untouched
by bare finger and disconnect the unit from power while
re-lamping.
3.
Use a clamp to hang the unit onto the truss fasten tight. Tie the
unit steadily onto the truss by winding a chain through the
bracket of the unit.
4.
Use for indoor only.
5.
Place the unit where there is efficient ventilation, away from any
flammable and explosive objects.
6.
Check that the rated power corresponds to the main supply.
III Re-lamping:
1. Unplug the fixture completely from the electrical outlet and wait for
15 minutes for cooling.
2. Unscrew the fixing screws of the cover of the unit.
3. Taking the lamp out of the unit body gently.
4. Place the new lamp into the unit and then fixing the cover.
IV Caution:
1. In order to reach a maximum of safety, the following points
should be carefully read and observed.
2. Ambient temperature should not exceed 40
℃.
3. Disconnect from the power supply before opening or replacement
of the lamp and fuse. Please be sure the lamp is cool before
replacement!
4. To avoid electrical shock, do not touch any live parts when the
unit is activated.
5. Call professionals for maintenance, no spare parts are included
with the unit. Always completely disconnect the fixture from
electric and allow to cool for 15 minutes when Replacing the
lamp or fuse
6. These units are for commercial use and contain no
user-serviceable parts inside. Servicing must be conducted by
qualified service person.
7. The lamp shall be changed if it has become damaged or thermally
deformed.
