LED SPOT80 

USER MANUAL V1.0 EN 

CAUTION!

Keep this device away from rain and moisture

! 

Unplug mains lead before opening the housing

!

For your own safety, please read this user manual carefully before you initially start-up. 

INTRODUCTION 

Thank you for having chosen

 LED SPOT80

. If you follow the instructions given in this manual, we are sure that you 

will enjoy this device for a long period of time. 

Features: 

*36 pcs high power 1W LEDs, RGB color mixing 
*Either sound-controlled or via DMX 
*5 DMX channels 
*Stand-alone operation with master/slave   

OPERATION 

Manual Mode (fixed color, w/o color changing w/o chasing) 

1. Link up more than 2 units or more and set Master and Slave 
Master: DIP switch 8 ON, the others at OFF                        Slave: DIP switch 1 and 10 at ON 

2. To set color by setting dip switches of Master unit: 

DIP 1 ON: Red LED at medium brightness; 
DIP 2 ON: Red LED at high brightness; 
DIP 3 ON: Green LED at medium brightness; 
DIP 4 ON: Green LED at high brightness; 
DIP 5 ON: Blue LED at medium brightness; 
DIP 6 ON: Blue LED at high brightness; 
 

※ 

All linked slave units’ color will be same as master unit 

※ 

The above settings cannot work with DMX controller. 

※ 

When two or more LEDs are in serial, settings applies to Master only. DO NOT make any settings on Slaves. 
Otherwise, there will be unexpected color changing. 

※ 

DO NOT set DIP switch 8 at ON. 

Sound-active Mode 

Master: set the master unit: Set DIP 8 at ON, the others at OFF 

When DIP 7 at ON, Colour hard changing with strobe by bass will be active 
When DIP 8 at ON, Colour hard changing without strobe by bass will be active 

Slave: set DIP switch 1 and 10 at ON   

Built-in Chases Mode 

1. To set Master and Slave 
Master: DIP switch 9 at ON                      Slave: DIP switch 9 at OFF, 10 at ON 

※ 

Built-in chases mode can be run a link consists of 4 pcs of units. 

2. To set built-in chase by setting DIP switch 1-3 of the Master.