screen, and audibly (unless disabled).

7. To take a 

RECTAL TEMPERATURE reading:

    

(newborn and older) Coat the probe tip with petroleum jelly.

    With your free hand, spread baby's buttocks apart. Gently
    insert the probe tip about half an inch to an inch (1.3 to 2.5
    centimeters) into the rectum, or until the silver tip disappears.
    When you hear beeping the measurement is complete and
    the thermometer will readout both, visibly on the display
    screen, and audibly (unless disabled).

8. To 

LISTEN AGAIN to the temperature readout: 

    Press the 

Speaker symbol button (      ) and your thermometer

    will recall and announce the last measurement taken.

9. To 

TURN OFF the thermometer:

    Press the 

ON/OFF button for less than 1 Second.  The unit will

    also turn off automatically after five minutes from the last use.

    

Battery Replacement

1. Replace the batteries in your 
    thermometer when the low 
    battery indicator appears on 
    the LCD display.
2. Remove the battery cover from 
    the back of the unit and remove 
    all three batteries.
3. Load three new batteries (size 
    AG10) so they are lined up with 
    the + sides to the right (nearest
    the latch indention) inside and 
    replace the cover.

    

Precautions

    should be disinfected with alcohol 
    or washed with soap and warm 
    water; the LCD display screen 
    should only be cleaned with a 
    towel as that part is not water-
    proof; 

Do Not place upper part 

    of thermometer into water or 
    wipe it with an overly moist towel.

    

Tips

    in the correct position to consistantly 
    measure temperature accurately.

    precise than underarm measurements. 

    18 months of use (or after approxi-
    mately 350 uses) for continued 
    accurate readings .

tempTalk

TM

70123

Voice Readout Digital Thermometer

    Temperature Range:    89.6ºF – 109.2ºF     32.0ºC – 42.9ºC

1. To 

TURN ON the thermometer: 

    Press the 

ON/OFF button for 1 Second. 

 the LCD screen will display

    “Please measure.” 
2. To disable or activate the 

VOICE READOUT function:

    While unit is off press the 

ON/OFF button for 4 Seconds. After

    3 seconds at one setting normal mode resumes.

3. To change voice readout 

LANGUAGE: 

    While unit is off press the 

ON/OFF button for 8 Seconds. 

    
    language readout to one of the following options:
           Code     Language          Code     Language

    After 3 seconds at one setting normal mode resumes.

4. To change readouts to 

CELSIUS (C) or FAHRENHEIT (F):

    While unit is off press the 

ON/OFF button for 12 Seconds.

    of measurement. After 3 seconds at one setting normal mode
    resumes.

5. To take an 

ORAL TEMPERATURE reading: 

    (3 months and older)  Place the probe tip under the tongue as
    near as possible to the area furthest back. 
    When you hear beeping the measurement is complete and
    the thermometer will readout both, visibly on the display
    screen, and audibly (unless disabled).

6. To take an 

UNDERARM TEMPERATURE reading: 

    Dry the underarm with a towel and place the probe tip 
     high in the armpit so the thermometer is perpendicular to
    the body, and position the arm across the chest so the tip is
    fully covered by bare skin.
    When you hear beeping the measurement is complete and
    the thermometer will readout both, visibly on the display

nutes from the last use.

s. 

LCD

Probe

Tip