HR2732 HR2734

(HR2732, HR2734)

(HR2732, HR2734)

(HR2730_MEA, 

HR2732, HR2734)

(HR2730)

Register your product and get support at

HR2730
HR2732
HR2734 

www.philips.com/welcome

Specifications are subject to change without notice
© 2012 Koninklijke Philips Electronics N.V.
All rights reserved.

HR2730_2732_2734_CEE1_UM_V1.1

English

1 Important

Read these instructions for use carefully before using the appliance and save them for future 

reference.
 
Danger

Do not immerse the motor unit in water nor rinse it under the tap. 

Do not connect the appliance to a timer switch. 

 
Warning

Before you connect the appliance to the power, make sure that the voltage indicated 

on the bottom of the appliance corresponds to the local power voltage. 

If the power cord, the plug, or other parts are damaged, do not use the appliance. 

If the power cord is damaged, you must have it replace by Philips, a service center 

This appliance is not intended for use by persons (including children) with reduced 

physical, sensory or mental capabilities, or lack of experience and knowledge, unless 

they have been given supervision or instruction concerning use of the appliance by a 

person responsible for their safety.

For their safety, do not allow children to play with the appliance.

Be very careful when you handle the cutter, especially when you remove it from the 

worm shaft and during cleaning. The cutting edges are very sharp!

Before you remove any accessory, switch the appliance off and unplug it.

hopper while the appliance is running. Only the pushers are to be used for this 

purpose.

 
Caution

The appliance is intended for household use only. 

Before you connect the appliance to the mains, make sure that the appliance is 

assembled correctly. 

Never use any accessories or parts from other manufacturers or that Philips does not 

invalid.

Always switch the appliance off by turning the switch knob to   . 

Do not let the appliance run unattended. 

Do not exceed the maximum operating time of 4 minutes under heavy load 

applications. 

Noise level: Lc = 87 dB [A]

Safety system (Fig. 6 and Fig. 7)

This appliance is equipped with overheat protection. If the appliance overheats, it switches 

off automatically. Unplug the appliance and let it cool down until room temperature. Then, 

put the mains plug back into the power outlet and switch on the appliance again. Please 

contact your Philips dealer or an authorized Philips service center if the overheat protection 

is activated too often.
HR2730 is equipped with mechanical protection. To protect the motor, the plastic gear has 

been designed to break if bones or utensils are fed into the appliance. When this happens, 

simply remove the broken gear and replace with the extra gear (Fig. 6).

In case the appliance is overloaded, it automatically activates the overload protection and 

switches off. If this occurs, set the switch knob to   , unplug the appliance and let it cool 

down for 15 minutes. Remove the residue inside the hopper and then press the overload 

reset button on the bottom of the motor unit (Fig. 7).

handled properly and according to the instructions in this user manual, the appliance is safe 

Recycling

  

Your product is designed and manufactured with high quality materials and components, 

which can be recycled and reused.
When you see the crossed-out wheel bin symbol attached to a product, it means the 

product is covered by the European Directive 2002/96/EC:

 

Never dispose of your product with other household waste. Please inform yourself about 

the local rules on the separate collection of electrical and electronic products. The correct 

disposal of your old product helps prevent potentially negative consequences on the 

environment and human health.

2 Introduction

that Philips offers, register your product at www.philips.com.
 
With this meat mincer, you can

mince meat 

make sausages

make kebbe (HR2730 Middle East Asia, HR2732 and HR2734 only)

Tip

  For more recipes, go to www.kitchen.philips.com.

3  What’s in the box (Fig. 1)

a 

 Hopper release button

Press and hold it when you remove the hopper.

b 

c 

Switch knob for power and reverse modes   /  / 

Switch off (   ) or on (  ) the meat mincer.

Switch to   to reverse the motor. 

d 

Power cord

e 

Pusher for the metal hopper

f 

g 

Extra gear for the worm shaft (HR2730 only)

h 

Worm shaft

i 

Cutter/Knife

j 

Hygienic stainless steel grinding discs

A: Coarse grinding disc (diameter of 8 mm)

B: Medium grinding disc (diameter of 5 mm)

C: Fine grinding disc (diameter of 3 mm) (HR2732 and HR2734 only)

k 

Screw ring

l 

Sausage horns

A: Large sausage horn (diameter of 22 mm)

B: Small sausage horn (diameter of 12 mm)

m 

Sausage separator

n 

A: Kebbe separator

B: Kebbe shaper

o 

p 

q 

r 

Innovative cleaning tool

A: HR2730 only

B: HR2732 and HR2734 only

Before you start, make sure you assemble according to Fig. 2-1.
For disassembly, refer to Fig. 3-1.

Note

  Never grind bones, nuts, or other hard items.

 

  Do not overload the appliance by pushing too much meat into the hopper. 

  Depending on the granularity of minced meat, select the proper grinding disc. You can also 

grind for more than one time.

 

Tip

  Remove bones, gristle, and sinews out of the meat as much as possible. 

  If the hopper is blocked, switch to   to reverse the motor and clear the leftover meat.

Recipe

Pozharskie Kotleti (Chicken cutlets)

Yield: 4 servings
Ingredients:

450 g chicken breast or readily ground chicken

200 g plain wheat bread

120 ml warm milk

6 Tbsp. unsalted butter

1/2 tsp. salt

1/8 tsp. black pepper

1/2 cup of bread crumbs, use more if needed

1 clove of minced garlic (optional)

15 ml vegetable oil (optional)

100 g mozzarella or Muenster cheese, cut into 5 cm long, 1.3 cm wide strips (optional)

 
Directions:

1 

Soak the bread in warm milk for several minutes.

2 
3 

Mince the mixture of minced bread and chicken.

5 

Add salt and pepper (as well as the minced garlic if you like) into the mixture, and then 

thoroughly mix the ingredients.

6 

Soak your hands in water, and then grab a portion of the mixture equal to the size of a 

tennis ball. Cover a piece of cheese in the mixture, and shape it into a patty. Make sure 

that the cheese is not exposed.

7 

Coat the patty with bread crumbs.

8 

Over medium-low heat, melt the butter, and then fry the patty on each side for three 

minutes, or until it turns golden brown in the melt butter.

9 

Bake the fried patties in the oven (preheated at 177°C) for 15 minutes.

10 

Serve the patties with your favorite side course.

Before you start, make sure you assemble according to Fig. 2-2.
For disassembly, refer to Fig. 3-2.

Note

  Do not block the air outlet grooves of the sausage horn.

  Do not make the sausages too thick in case the sausage skin is overstretched.

  Keep the sausage skin wet to prevent it from sticking on the sausage horn.

 

Recipe

Sausages

Ingredients:

4,500 g ground pork 

5 Tbsp. of salt 

1 Tbsp. of ground white pepper 

2 Tbsp. of rubbed sage

1 tsp. of ginger

1 Tbsp. of nutmeg 

1 Tbsp. of thyme

470 ml ice water

1 Tbsp. of ground hot red pepper

 
Directions:

1 

Mince the meat with the coarse grinding disc.

2 

Thoroughly mix the minced meat and other ingredients.

3 

Follow the instructions in the section “

“ to make your own sausages.

Before you start, make sure you assemble according to Fig. 2-3.
For disassembly, refer to Fig. 3-3.

 

Recipe

Kebbe

Yield: 5-8 servings
Ingredients:

Outer casing

500 g lamb or fat-free mutton, cut into strips

500 g bulgur wheat, washed and drained 

1 small onion

Filling

400 g lamb, cut into strips 

15 ml oil

5-10 ml ground allspice 

salt and pepper

 
Directions:

Outer casing

1)

2) Thoroughly mix the minced ingredients, and then mince the mixture twice again.

3) Use the kebbe maker to shape the mixture into kebbe casing.
Filling

1) Mince the meat with the medium grinding disc. 

2) Fry the onion chops until they turn golden brown.

3) Add the minced meat and other ingredients in, and then cook for 1-2 minutes.

Cooking

1)

2) Heat the oil for deep frying (190°C). 

3) Deep fry the kebbe for 3-4 minutes, or until it turns golden brown.

 

into contact with food.

Before you remove accessories or clean the motor unit, switch off and unplug the 

appliance.

Do not immerse the motor unit in water nor rinse it under the tap.

Do not clean the metal parts in a dishwasher.

Clean the main unit with a moist cloth.

Pass pieces of bread through the cutter housing to remove any meat left.

Wash removable parts with a soft brush in soapy water, rinse them with clear water, 

and then dry them with soft cloth or tissues immediately.

Lightly brush the metal parts with fat or oil to prevent rusting. 

Tip

  Use the innovative cleaning tool to remove the remains stuck in the grinding discs. rinse them 

with clear water, and then dry them with soft cloth or tissues immediately.

8  Replace the gear (HR2730 only) (Fig. 6)

One extra gear is bundled with the product. If the original gear is broken, replace it with the 

extra one.

3

3-1

3-2

3-3

2

2-1

2-2

2-3

b

a

f

e

k

h

g

c

d

A

B

C

j

i

l

B

A

A

B

p

o

q

m

A

B

n

r

1

5

6

7

HR2730

HR2730

(HR2732  

EN User manual 
RU

UK

1/2

         3140 035 29081