Инструкция: предусилитель ARCAM FMJ C30

Инструкция для ARCAM FMJ C30

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

Pre Amplifier C30
Power Amplifier P35
Power Amplifier P1

Préamplificateur C30
Amplificateur de Puissance P35
Amplificateur de Puissance P1

Vorverstärker C30
Vollverstärker

P35

Vollverstärker

Оглавление инструкции

Страница 1 из 18
Pre Amplifier C30 Power Amplifier P35 Power Amplifier P1 Préamplificateur C30 Amplificateur de Puissance P35 Amplificateur de Puissance P1 Vorverstärker C30 Vollverstärker P35 Vollverstärker P1
Страница 2 из 18
Safety guidelines CAUTION ATTENTION RISK OF ELECTRIC SHOCK DO NOT OPEN RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR 8. Cleaning Unplug the unit from the mains supply before cleaning. The case should normally only require a wipe with a soft, damp, lintfree cloth. Do not use paint thinners or other
Страница 3 из 18
Thank you for buying this quality Arcam product. CONTENTS This handbook is for the following items:  C30 pre-amplifier  P35 power amplifier  P1 power amplifier. Safety guidelines ............................................................................. 2 Important safety instructions
Страница 4 из 18
Installation: C30 pre-amplifier L PHONO R VOLTAGE SELECT POWER INLET TRIG OUT REMOTE IN L L R R 115/230V R BUFFERED DIRECT L PRE OUT MM MC RECORD PLAY OUT IN TAPE/PROC RECORD PLAY OUT IN VCR/TAPE 2 DVD AV TUNER CD AUX the amplifier. This is perfectly normal. If the unit is to be left unused for an
Страница 5 из 18
3 TRIG OUT and REMOTE IN (12V in and out) – These connections are intended for use in multi-room installations. CONNECTING TO OTHER EQUIPMENT – This output provides a 12V signal whenever the unit is switched on (i.e., not off or in standby).This signal can be used to switch on automatically power
Страница 6 из 18
Using your C30 pre-amplifier C30 PRE-AMPLIFIER ENTER MODE RECORD SELECT PHONO/AUX CD If your amplifier has not been installed for you, you should first read the section ‘Installation: C30 pre-amplifier’ on page 5. bn Switches the unit on and off. VCR TAPE TONE MUTE DISPLAY PHONES POWER It is
Страница 7 из 18
RECORDING With the C30 it is possible to listen to and record from one source, or to listen to one source while recording another. RECORD Englis h Both sets of tape sockets are identical in sensitivity and suitable for use with almost any type of recorder (cassette, CDR, MD, VCR, reel-toreel,
Страница 8 из 18
Setting up your C30 pre-amplifier INTRODUCTION Volume Resolution – Standard, fine or Reference. ‘Standard’ and ‘Fine’ represent different levels of volume control sensitivity. The ‘Reference’ setting gives absolute increments in 0.5dB steps. The C30 allows you to adjust listening settings to suit
Страница 9 из 18
Using the remote control CR-389 Remote Control Englis h The CR-389 remote control gives access to all functions available on the front panel of the C30. It also has controls to operate Arcam CD players, AM/FM tuners and DAB tuners. The remote control transmits Philips RC-5 type codes. TUNER These
Страница 10 из 18
Installation: P35 and P1 power amplifiers + R/CH1 – + L/CH2 – + CTR/CH3 – SP2 SP2 4 – 16 OHMS TRIG OUT 230V VOLTAGE SELECT SP1 REMOTE IN POWER INLET + R/CH1 – AUDIO LINK SP1 R + L/CH2 – CTR/CH3 4 – 16 OHMS L IN AUDIO IN OUT + CTR/CH3 – OUT Optional Third Channel Module – provides a third 90W
Страница 11 из 18
There are two options for connecting the speaker cable to the amplifier: CONNECTING TO OTHER EQUIPMENT AUDIO IN (P35) AUDIO IN and BALANCED AUDIO IN (P1) 1. Strip back the insulation on the wire to reveal about 2cm of conductor (the metal inside the cable). Connect one of these inputs to the output
Страница 12 из 18
Using your power amplifier P35 POWER AMPLIFIER SP1 SP2 POWER P35 POWER AMPLIFIER: FRONT PANEL P1 POWER AMPLIFIER POWER P1 POWER AMPLIFIER: FRONT PANEL POWER (AND POWER INDICATOR LIGHT) SP1 AND SP2 (P35 ONLY) This button switches the unit on and off. The light indicates the status of the amplifier.
Страница 13 из 18
BEFORE YOU START BI-AMPING YOUR SYSTEM The performance of your system can be further enhanced over that achieved with bi-wiring, by extending the principle one stage further to include separate amplification for the low and high frequency drive units in each loudspeaker enclosure. WARNING: Do not
Страница 14 из 18
Technical specifications C30 P35 Continuous power output (20Hz—20kHz at 0.5% THD), per channel Both channels, 8Ω, 20Hz—20kHz Single channel, 8Ω, 20Hz—20kHz Both channels, 4Ω, 20Hz—20kHz Single channel, 4Ω, at 1kHz Three channels, 8Ω, 20Hz—20kHz Harmonic distortion, 80% power, 8Ω at 1kHz Inputs
Страница 15 из 18
Remote-control codes Englis h The following table gives the IR-commands accepted by the C30. Power commands Command Power toggle Power-on Power-off Decimal Code 16–12 16–123 16–124 Source selection commands Command PHONO select AV select TUNER select DVD select TAPE select VCR select CD select AUX
Страница 16 из 18
Service information Before returning your amplifier for service, please check the following: AMPLIFIER DOES NOT SWITCH BACK ON SOUND CUTS OUT FOR NO REASON The C30, P35 and P1 amplifiers have a protection mechanism which is activated if you switch the unit on immediately after turning it off. If
Страница 17 из 18
Englis h NOTES 17
Страница 18 из 18

Инструкция для ARCAM FMJ C30

Инструкции и руководства похожие на ARCAM FMJ C30

Другие инструкции и руководства из категории предусилитель