8

GB

Three-phase 400

Connecting the electricity supply cable to the mains

If the appliance is being connected directly to the 
electricity mains an omnipolar switch must be installed 
with a minimum opening of 3 mm between contacts.

!

 The installer must ensure that the correct electrical 

connection has been made and that it is fully compliant 
with safety regulations.

Before connecting the appliance to the power supply, 
make sure that:
•  The appliance is earthed and the plug is compliant 

with the law.

•  The socket can withstand the maximum power of 

the appliance, which is indicated on the data plate 
located on the appliance itself.

•  The voltage falls within the range of values indicated 

on the data plate.

•  The socket is compatible with the plug of the 

appliance. If the socket is incompatible with the 
plug, ask an authorised technician to replace it. Do 
not use extension cords or multiple sockets.

!

 Once the appliance has been installed, the power 

supply cable and the electrical socket must be easily 
accessible.

!

 The cable must not be bent or compressed.

!

 The cable must be checked regularly and replaced 

by authorised technicians only.

!

The manufacturer declines any liability should 

these safety measures not be observed.

5

1

2

3

4

U-bolt

connection support

Phase Phase

Phase

Neutral Earth

Voltage and 

mains frequency 

Electrical connections 

Terminal board 

400V 3-N ~  

50/60 Hz 

Three-phase 400 

C

A

A

B

A

E

D

A

A

C

D

G

F

E

E

E

Switching on the glass ceramic hob

Traditional cooking zones

Traditional cooking zones (A) consist of circular heating 

elements. They turn red approximately ten seconds after they 

have been switched on.

Each cooking zone is fitted with a control knob (D) which 

allows you to select from 12 different temperature settings 

between a minimum of 1 and a maximum of 12.

Extendable cooking zones*

The extendable radiant elements (B and F) are distinguished 

by the fact that they have a double heating zone. You can 

switch the smaller internal cooking zone on separately, or 
both the external and internal zones together.

Circular extendable cooking zones*

The control knob (D) allows you to choose between two 

power levels, which may both be adjusted between a 

minimum value of 1 and a maximum of 12:

•  The lowest power level can be set by turning the knob 

clockwise from 1 to 12.

•  Turn the knob completely round (

), until you hear a 

*

 Only available in certain models.