Y O U R S U C C E S S I S O U R C O N C E R N !
.
р
5
CONNECTING TO PC AND TRANSFERRING DATA
MEMORY CARD
Tips to extend battery life:
1.New battery will work best of all after 2-3full charging and discharging.
2. Streaming audio or video apps use a lot of battery life.
3. Disable wireless network positioning.
4. Switch off Wi-Fi
,
if you’re not close to a strong Wi-Fi signal for extended
periods
of time.
5. Use a quick screen timeout.
6. Reduce brightness to a comfortable level.
7. Widgets that access
Web consume more power than widgets that do not.
Note:
Do not use other adapters to charge the Tablet which can cause damage to
the battery.
When unit is connected to PC via USB cable, the USB-icon appears at the
statu
s
.
bar. Select
USB connected
, the
n
Press
OK
To remove the tablet safely, tap
Turn off USB storage
.
Transferring contents from computer:
•
To t
ransfer
contents into the device, connect it to PC via supplied USB cable.
• Upon successful connection to PC, turn to the device, touch a
nd hold the USB
connection icon on status bar, drag downwards to display a current list.
•
Select
USB connected
, then press on
Turn
on
USB storage
to enter USB
mode and all operation will be halted.
• Go to [My Computer], double click on the removable
disk to open.
• Perform normal file management oper
ation like other USB device.
I
nsert the card correctly with the contact pin. Pushing the card in you should hear
a click when the card is
f
ixed
correctly. You may damage card and the device if
M
icroSD card is not inserted correctly. To remove
M
icroSD card push the card
once again until it clicks.
•
When a
M
icroSD card is inserted in or ejected from the device it may take few
seconds for the device to update the content. Please avoid inserting or ejecting
card when other operation is running as this may cause the system hang.
•
Do not remove the card
,
if the content inside the card is being played. This
will halt the operation of the device and cause the device to restart.
• If the system does not respond
,
press the button [Reset].
