EN
5
If the light of the 1st auxiliary function
on the left hand side is flashing
It is in the child-lock mode. (See. Child-lock)
If the cover and washing light on the
program follow-up indicator is
flashing and the end light is
constantly on
The program selection knob may be in-between
position.
Readjust the program by turning the program
selection knob. If the warning continues, contact
the authorized service.
If the light of Start/Pause/Cancel
button starts to flashing after a short
time you start your machine
The door is unlocked. Open and close the door
again and restart the washing program.
If the “Washing” light on the program
follow-up indicator is flashing
The water may be cut or the taps may be closed.
Check the taps. Turn off your machine and restart.
If the fault persists, unplug your machine, close the
taps and contact the authorized service.
If the program can not be started or
selected
Machine may be in the self-protection mode due to the
substructure problems (grid voltage, water pressure
and etc.)
Therefore, you can not start or select a program. Press
Start/Pause/Cancel button for 3 seconds and return
the machine to the factory settings. (See.Cancelling a
Program)
If the water is cut while your machine
is operating, the current program
does not proceed. To continue the
program
Press “Start/Pause/Cancel” button, program will
proceed.
Your machine may stop due to the
low voltage
Wait for a while. When the voltage reaches to a
normal level your machine will start to operate.
During the production, some water
may have remained in your machine
because of the quality control
processes.
This does not cause any damage to your machine.
You have selected the program
in your machine and pressed the
“Start/Pause/Cancel” button but the
machine did not start
The plug of your machine may not be plugged in a
grounded outlet, front cover may not be closed or
the fuse may be blown.
Is water coming from under your
machine
Check the water inlet and drainage hoses. Are they
well mounted? Gaskets of the water inlet hoses
may not be well seated. If the problem is none of
them, the pump filter may not be well closed.
Is the water drained directly?
Check if the drainage hose is connected as
described in the user guide.
During the water drainage, you may
hear water sound from the pump
This sound is normal.
Is foam running over the detergent
drawer?
Check if your detergent is suitable for automatic
machine. Use the recommended amount of
detergent in your next washing.
If sometimes you are not satisfied
with the rinsing and spinning
efficiency (laundries have
detergent remnants or they are not
dry enough)?
Make sure that you have selected the correct
program, you have adjusted the speed adjusting/
decrease button correctly and you have loaded the
right laundries for the program you have chosen, try
again when the voltage is normal.
Things to do Before Calling the Authorized Service
