8 

How to assemble your monitor hardware  

2. Connect the PC video cable.   

Connect the plug of the D-Sub cable (at the end without 
the ferrite filter) to the monitor D-Sub socket. Connect the 
other plug of the D-Sub cable (at the end with the ferrite 
filter) to the computer video D-Sub socket. 

Tighten all finger screws to prevent the plugs from acci-
dently falling out during use.

3. Connect the power cable to the monitor.

Plug one end of the power cord into the socket labelled 
‘POWER IN’ on the rear of the monitor. Do not connect 
the other end to a power point just yet. 

4. Route the cables via the cable clip.

Release the cable retaining clip by squeezing the clip 
inwards as illustrated. Position the cables together and 
reinsert the clip over them to retain the cables neatly in 
place behind the monitor stand.