7 

How to install your monitor hardware

2. Connect the video cable.   

Connect the plug of the D-Sub cable (at the end without 
the ferrite filter) to the monitor D-Sub socket. Connect 
the other plug of the D-Sub cable (at the end with the 
ferrite filter) to the computer video D-Sub socket. 

Tighten all finger screws to prevent the plugs from 
accidently falling out during use.

3. Connect the power cable to the monitor.

Plug one end of the power cord into the socket labelled
’POWER IN’ on the rear of the monitor. Do not connect
the other end to a power point just yet. 

4. Route the cables via the loose bracket.

Release the cable retaining clip by squeezing the clip
inwards as illustrated. Position the cables together and
reinsert  the  clip  over  them  to  retain  the  cables  neatly  in
place behind the monitor stand.