Operation
18
2.
When the function is activated for the first time,
a prompt will display on the screen. Use the
5
or
6
buttons to select a number for each digit
of the password. Use the
3
or
4
buttons to
move between the digits of the password..
3.
When all digits are entered and the password is
ready, press Auto to confirm. A confirmation
message displays.
IMPORTANT: Write your selected password down here in this manual so that it is available to
you should you ever forget it.
Password: __ __ __ __
Keep this manual in a safe place.
i. Press Auto to continue. The set-up is finished when the message “Password setup
completed” displays.
ii. Press
5
to go back to the previous
screen and re-enter four digits.
iii. Press
6
to cancel the password
set-up and return to the on-screen
menu.
If you forget the password:
You will be asked to enter the four digit password every time you turn on the projector. If
you enter the wrong password, the password error message displays. You can retry by
turning off the projector (by pressing Power) and start again, or if you did not record the
password in this manual, and you absolutely do not remember it, you can use the password
recall procedure.
To enter the password recall procedure:
Press and hold
4
for 5 seconds. The projector will display a coded number on the screen.
Seek help from the local BenQ service center to decode the number. You may be required to
provide proof of purchase documentation to verify that you are an authorized user of the
projector.
To change the password:
1. Open the on-screen menu and go to
Setting > Change Password.
2. Press
3
or
4
. A “Change Password” message displays.
3. Enter the old password.
i. If the password is correct, you can go on to enter new password.
IMPORTANT: Write your selected password down here in this manual so that it is available to
you should you ever forget it.
Password: __ __ __ __
Keep this manual in a safe place.
ii. If the password is incorrect, a “Password Error” message displays. Press
5
to try
again or press
6
to cancel.
4. Check the new password.
i. Pressing Auto completes the procedure.
ii. Press
5
to try again.
iii. Press
6
to cancel the set-up and return to the on-screen menu.
Password Setup
Enter Password
Press Auto to Confirm
Press
5
or
6
to change number
Press
3
or
4
to move
0
0
0
0
Password Setup
Do you want to use 0 0 0 0 as your password?
Yes Auto No
5
Cancel
6
