![background image](/i/bosch/97579/bosch-tes-80329-rw-veroselection-300/h/bosch-tes-80329-rw-veroselection-300-025.png)
21
TES80.. | 04/2013
en
Descaling
Duration: approx. 30 minutes.
Cleaning and service
Descale
start
Clean
The
start
button
8
flashes while the different
descaling processes are running.
The figures on the top right indicate the
progress of the programme.
Important:
If there is a water filter
29
in
the water tank
11
, it needs to be removed
before the service programme is run.
●
Press the
à
button
3
.
Descale
start
●
Press the
start
button
8
; the display
5
will
guide you through the programme.
Empty drip tray
Replace drip tray
●
Empty the drip tray
23
and reinsert it.
Place 1 l container
Place suction pipe in container
start
● Place a container with 1 litre capacity
under
the milk frother
10
.
●
Place the end of the suction pipe
10d
in
the container.
●
Press the
start
button
8
.
Remove filter
start
Info:
If the water filter
29
is activated, the
display will prompt you to remove the filter
29
, then press the
start
button
8
again.
Add 0.5 l water and descaler
start
●
Pour lukewarm water into the empty water
tank
11
up to the “
0.5 l
” mark and then
dissolve two Bosch descaling tablets in it.
●
Press the
start
button
8
. The descaling
programme will now run for about
20 minutes.
Descaling
Not enough descaling fluid.
Refill fluid
start
Info:
If there is not enough descaling solu-
tion in the water tank
11
, the corresponding
prompt is displayed. Pour in descaling solu
-
tion and press the
start
button
8
again.
Clean and refill water tank
start
●
Rinse the water tank
11
and refill it with
fresh water up to the “
max
” mark.
●
Press the
start
button
8
. The descaling
programme now runs for about 1 minute
and rinses the appliance.
Descaling
Empty drip tray
Replace drip tray
●
Empty the drip tray
23
and reinsert it.
Replace the filter if one is being used. The
appliance is ready for use again.
Important:
Wipe down the appliance
using a soft, damp cloth to immediately
remove any descaler residue. Such residue
can cause corrosion. New sponge cloths
may contain salts. Salts can cause rust
film on stainless steel and must therefore
be washed out thoroughly before use.
Thoroughly clean the suction pipe
10d
of
the milk frother.
TES803_805_807_1RW.indb 21
08.05.2013 14:53:02