[Страница 11/20] - Руководство пользователя: акустическая система BOSE 901 Direct/Reflecting

Инструкция для BOSE 901 Direct/Reflecting

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

Setting Up

2. Use the twin cable assemblies (with two connectors at each end) that are supplied with the

equalizer. Use one connector for the right (R) channel connections and the other connector
for the left (L) channel connections.

3. Connect the amplifier INPUT of the Bose

901

active equalizer to the PRE AMP OUT jacks

of the receiver or amplifier. Connect right channel to right channel and left to left.

4. Connect the amplifier OUTPUT of the active equalizer to the MAIN AMP IN jacks on the

receiver or amplifier. Connect right channel to right channel and left to left.

5. Plug the power cord of the 901 active equalizer into one of the switched outlets on the

receiver so that it will be powered when the receiver is switched on.

Note:

This connection method does not allow you to connect a tape deck directly to the active

equalizer. Connect it to the receiver instead.

Check to see that the 901 speakers are connected to the receiver MAIN or FRONT speaker
jacks. In this way the 901 active equalizer signals will reach only the 901 speakers – the front
channels of your home theater – and not any non-901 speakers used as center and surround
channels.

Call Bose Corporation for assistance with the connection of additional speakers or signal
processing equipment. Refer to the address information inside the back cover of this guide.

A free booklet is available (USA only): Guide to Optional System Connections for Bose 901
Direct/Reflecting

Speaker Systems. Ask for part number 149393.

Figure 7

Home theater receiver
connections

Оглавление инструкции

Страница 1 из 21
The Bose® 901® Series VI Direct/Reflecting® Speaker System Owner’s Guide
Страница 2 из 21
Safety Information WARNING: To reduce the risk of fire or electric shock, do not expose the system to rain or moisture. CAUTION CAUTION AV I S RISK OF ELECTRICAL SHOCK DO NOT OPEN RISQUE DE CHOC ÉLECTRIQUE NE PAS OUVRIR CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK).
Страница 3 из 21
Contents Where to find… Contents Where to find… ............................................................................................................. 3 Warranty period ............................................................................................................ 3 Customer
Страница 4 из 21
Setting Up Before you begin Thank you for purchasing the Bose® 901® Series VI Direct/Reflecting® speakers. They represent the best in Bose Corporation speaker design and engineering and will give you many years of listening pleasure. The installation and operating principles of this system are
Страница 5 из 21
Setting Up System Compatibility Bose® 901® Series VI speakers and Series VI active equalizer work with your stereo components to produce a superb music system. The active equalizer is an integral part of the system and may be connected in a variety of ways, depending on the components you have. The
Страница 6 из 21
Setting Up Choosing the location for your speakers Choose locations for your 901® speakers that use the walls to best advantage by reflecting sound throughout the listening room. Refer to the drawing on page 7. Guidelines for placement Place the speakers along the same wall (see Figure 3): • 4 to
Страница 7 из 21
Setting Up Hardware needed for ceiling suspension • Screw hooks support the chains at the ceiling. They must have at least a #10 wood thread with a shank diameter of at least 3⁄16 inch (4.5 mm). They should be long enough to go through any plasterboard and still have at least one inch (25 mm) of
Страница 8 из 21
Setting Up Speaker connections With your speakers in their chosen locations, connect them to the receiver. Choosing the wire It is important to use the right thickness of speaker wire. For distances of up to 30 feet (9 m), 18 gauge (.075 mm2) 2-conductor wire works well. For distances greater than
Страница 9 из 21
Setting Up Checking the speaker connections Make sure the terminal knurled nut is tightened down firmly. Any gap between the wire and terminal can cause heat build up. Check to be sure the wires are connected positive to positive (+ to +) and negative to negative (- to -). Make sure no loose
Страница 10 из 21
Setting Up 3. Connect one end of a cable to the AMPLIFIER INPUT jacks on the 901® active equalizer. a. Insert the first connector firmly into the INPUT jack marked R. b. Insert the second connector into the INPUT jack marked L. 4. Connect the other end of the cable to the OUT or RECORD jacks on
Страница 11 из 21
Setting Up 2. Use the twin cable assemblies (with two connectors at each end) that are supplied with the equalizer. Use one connector for the right (R) channel connections and the other connector for the left (L) channel connections. 3. Connect the amplifier INPUT of the Bose® 901® active equalizer
Страница 12 из 21
Setting Up Testing the speakers and equalizer Choose the test method appropriate to your system: To test the TAPE MONITOR connection 1. Turn off or disconnect any non-901 speakers or headphones that may be connected. 2. On the 901® active equalizer, press the MONITOR button IN to TAPE, and the BASS
Страница 13 из 21
Setting Up 5. Move the receiver BALANCE control to the extreme left and then to the extreme right. This tests the left and right channel orientation. If the channels are reversed, check the connections. 6. Turn off the receiver and temporarily unplug the 901® active equalizer from its AC (mains)
Страница 14 из 21
Using Your 901® Series VI Speaker System Playing your speakers Always use the 901® active equalizer when playing your 901 speakers. How you set the equalizer depends on how it is connected to your receiver. When connected to TAPE MONITOR Press your receiver TAPE MONITOR button to the IN or MONITOR
Страница 15 из 21
Using Your 901® Series VI Speaker System Adjusting the sound Adjust the sound using the MID-TREBLE and MID-BASS sliders and BASS control on the 901® active equalizer. Use the tone controls on your receiver only after the MID-TREBLE and MID-BASS sliders have been set according to the procedures
Страница 16 из 21
Using Your 901® Series VI Speaker System Equalizer compatibility The Bose® 901® Series VI active equalizer is designed for specific use with Bose 901 Series VI speakers. It may also be used with 901 Series V speakers. WARNING: Bose 901 Series I, II, III, or IV speakers require a substantially
Страница 17 из 21
Maintaining Your 901®Series VI Speaker System Cleaning your speakers If your 901® speakers have a painted surface, clean with a soft damp cloth. If necessary, use a mild detergent such as dish soap. If the speakers have a wood veneer finish, clean them with wood furniture polish. You may vacuum the
Страница 18 из 21
Product Information Technical information Bose® 901® Series VI Direct/Reflecting® Loudspeakers Transducer complement 1 901 Series VI active equalizer Input Impedance Nine (9) 4 /2" (11.4 cm) full-range Helical Voice Coil drivers in each cabinet 47 k ohms (47 kΩ) Energy dispersion 1 k ohm 89% by
Страница 19 из 21
19
Страница 21 из 21

Инструкция для BOSE 901 Direct/Reflecting

Инструкции и руководства похожие на BOSE 901 Direct/Reflecting

Другие инструкции и руководства из категории акустическая система