6

English

Setting Up

4. Connecting the cube arrays to the Acoustimass

®

 module

Select one pair of wires, and locate the terminal tab on the rear of the left cube array.

1. Just press the terminal tab on the back of the speaker to insert the marked wire into the

red (+) terminal and the plain wire into the black (–) terminal (Figure 3).

2. Release the terminal tab and both wires will be held securely.

3. Repeat this process with the other pair of wires and the right cube array.

Figure 3

Connecting a cube array

CAUTION:

 Do not connect your amplifier or receiver directly to the cube arrays. Cube

arrays must be connected directly to the Acoustimass module or damage will result.

4. Next, locate the terminals marked OUTPUTS TO CUBE SPEAKERS on the rear of the

Acoustimass module (Figure 4).

5. Connect the other ends of the wires from the left cube array to the pair of terminals

marked L. Make sure that the marked wire is connected to the positive (+) and the plain
wire is connected to the negative (–) terminal.

6. Now, repeat step 5 for the right cube array, connecting its wires to the terminals marked R.

Figure 4

Connecting cube arrays to the
Acoustimass module

Marked wire

to red terminal

From left cube speaker

From right cube speaker

To  receiver or amplifier