xStack® DES-3528/DES-3552 Series Layer 2 Fast Ethernet Managed Switch CLI Reference Guide
9
traceroute6 upload
DES-3528:admin#
Figure 2-5. The Next Available Commands Prompt
The top-level commands consist of commands such as
show
or
config
. Most of these commands require one or
more parameters to narrow the top-level command. This is equivalent to
show
what?
or
config
what? Where the
what? is the next parameter.
For example, if users enter the
show
command with no additional parameters, the CLI will then display all of the
possible next parameters.
DES-3528:admin# show
Command: show
Next possible completions:
802.1p 802.1x access_profile account
accounting acct_client address_binding
arp_spoofing_prevention arpentry asymmetric_vlan
attack_log auth_client auth_diagnostics
auth_session_statistics auth_statistics authen
authen_enable authen_login authen_policy authentication
authorization autoconfig bandwidth_control bpdu_protection
cfm command_history config cpu
cpu_filter current_config device_status dhcp
dhcp_local_relay dhcp_relay dhcp_server dhcpv6_relay
dnsr dot1v_protocol_group dscp
duld erps error ethernet_oam
fdb filter firmware flow_meter
gratuitous_arp greeting_message gvrp hol_prevention
igmp_snooping ipfdb ipif
ipif_ipv6_link_local_auto iproute ipv6
ipv6route jumbo_frame jwac l2protocol_tunnel
lacp_port limited_multicast_addr link_aggregation
lldp local_route log log_save_timing
log_software_module loopdetect
mac_based_access_control mac_based_access_control_local
mac_based_vlan mac_notification max_mcast_group
mcast_filter_profile mef_l2_protocols
mef_vlan_preservation mirror mld_snooping
multicast multicast_fdb packet per_queue
poe policy_route port port_security
port_security_entry port_vlan ports
pppoe pvid qinq radius
rmon router_ports rspan safeguard_engine
scheduling scheduling_mechanism serial_port
session sflow sim snmp
sntp sred ssh ssl
stack_device stack_information stacking_mode stp
subnet_vlan switch syslog system_severity
tech_support terminal time time_range
traffic traffic_segmentation trap
trusted_host utilization vlan vlan_counter
vlan_precedence vlan_translation vlan_trunk voice_vlan
wac
DES-3528:admin#
Figure 2-6. Next possible completions: Show Command
In the above example, all of the possible next parameters for the
show
command are displayed. At the next command
prompt, the up arrow was used to re-enter the
show
command, followed by the
account
parameter. The CLI then
displays the user accounts configured on the Switch.