6.

Lift the retention clasp in an upward direction and release the fingerprint reader cable outward to remove it from 

the system board. Lift the base cover away from the computer.

Installing the Base Cover

1.

Attach the fingerprint reader flex cable from the base cover to the system board.

2.

Attach the base cover to the computer.

3.

Push the edges of the base cover into the securing clips until they are fully engaged.

4.

Tighten the screws to secure the base cover.

5.

Install the battery.

6.

Follow the procedures in 

After Working Inside Your Computer.

Removing the Front Camera

1.

Follow the procedures in 

Before Working Inside Your Computer

.

2.

Remove the:
a) battery
b) base cover

3.

Lift up the connector latch and disconnect the camera cable. Remove the screw that secures the camera module 

to the computer. Remove the camera module from the computer.

17