![background image](/i/elenberg/121182/elenberg-wh11-20/h/elenberg-wh11-20-010.png)
10
Drill two holes in wall and have a distance of 1.8 m from the ground. The
diameter of the hole just contained the inflated plastic pipe. After tucked
the inflated plastic pipe, fixed pothook on the pipe with screw. Make sure
pothook fastness and hang the heater. The clip under the pothook should
be inserted rabbet of the heater bottom.
Notes:
1. The heater should be hung on the wall and make the wind outlet down
or be placed on flat appliance. You must not place it precipitately or
tipsily.
2. Please do not use the heater in the place where full of combustible or
explosive gas. Don’t cover the wind outlet.
3. If the supply cord is damaged, it must be replaced by the manufacture
or its service agent or a similarly qualified person in order to avoid a
hazard
4. If nobody is in or you are repairing the heater, please put off the plug-
in.
5. Please don’t touch the heater by the wet hand or other conductor.
6. Motor is out of order, please make it stop immediately.
7. During using the heater, please do not open the door or window con-
tinually otherwise it will influence the heating effect.
8. If want to close the machine, press the on/off switch to off, then the ma-
chine keep the fan working about 30 seconds until it blowing out cool
INSTALLATION