![background image](/i/gigabyte/153571/gigabyte-gc-ptv-taf/h/gigabyte-gc-ptv-taf-009.png)
Installation
- 9 -
English
2.4. Hardware Installation
Step 1.
Take the TV card out of the anti-static bag, and carefully,
firmly insert the TV card into the PCI slot.
Step 2.
Secure the TV card to the computer chassis with screws,
and then replace the computer case.
Step 3.
Connect the FM antenna, digital TV antenna and stereo
sound cable to the TV card. (See the "Components" section
previously for the connector information.) Connect the USB
receiver
(Note 1)
for the remote control to a USB port on your
computer.
Step 4.
Extend the FM antenna and digital TV antenna, and place them on a location with better signal
reception
(Note 2)
.
The hardware installation is then completed!
Now you can connect the computer to an electrical outlet and power on the computer. Follow the
instructions in the next section for driver and software installation for the TV card.
(Note 1) Please place the receiver at a location where remote control signals are available.
(Note 2) Find a location in your house where can get the best reception. The digital TV signals are
transmitted via a ground-based transmitter. Please place the antenna near the window and
away from sheltering buildings as possible as you can for better signal reception.