Инструкция для GMC ALL-NEW YUKON DENALI (2015)

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

Black plate (55,1)

GMC Yukon Denali/Yukon XL Denali Owner Manual (GMNA-Localizing-U.S./

Canada/Mexico-7063681) - 2015 - 1st Edition - 6/6/14

Vehicle Care

10-55

sensor matching process. See
"TPMS Sensor Matching
Process" later in this section.

One or more TPMS sensors are
missing or damaged. The
malfunction light and the DIC
message should go off when the
TPMS sensors are installed and
the sensor matching process is
performed successfully. See
your dealer for service.

Replacement tires or wheels do
not match the original equipment
tires or wheels. Tires and wheels
other than those recommended
could prevent the TPMS from
functioning properly. See

Buying

New Tires on page 10-59

Operating electronic devices or
being near facilities using radio
wave frequencies similar to the
TPMS could cause the TPMS
sensors to malfunction.

If the TPMS is not functioning
properly, it cannot detect or signal a
low tire condition. See your dealer

for service if the TPMS malfunction
light and DIC message come on
and stay on.

TPMS Sensor Matching
Process

Each TPMS sensor has a unique
identification code. The identification
code needs to be matched to a new
tire/wheel position after rotating the
vehicle

’

s tires or replacing one or

more of the TPMS sensors. Also,
the TPMS sensor matching process
should be performed after replacing
a spare tire with a road tire
containing the TPMS sensor. The
malfunction light and the DIC
message should go off at the next
ignition cycle. The sensors are
matched to the tire/wheel positions,
using a TPMS relearn tool, in the
following order: driver side front tire,
passenger side front tire, passenger
side rear tire, and driver side rear.
See your dealer for service or to
purchase a relearn tool. A TPMS
relearn tool can also be purchased.
See Tire Pressure Monitor

Sensor Activation Tool at
www.gmtoolsandequipment.com or
call 1-800-GM TOOLS
(1-800-468-6657).

There are two minutes to match the
first tire/wheel position, and
five minutes overall to match all four
tire/wheel positions. If it takes
longer, the matching process stops
and must be restarted.

The TPMS sensor matching
process is:

1. Set the parking brake.

2. Place the vehicle power mode in

ON/RUN/START. See

Ignition

Positions on page 9-20

3. Make sure the Tire Pressure info

page option is turned on. The
info pages on the DIC can be
turned on and off through the
Settings menu. See

Driver

Information Center (DIC) on
page 5-29