Инструкция для GMC SAVANA CARGO (2014)

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

Black plate (19,1)

GMC Savana Owner Manual (GMNA-Localizing-U.S./Canada-6014682) -

2014 - crc - 4/9/13

Vehicle Care

10-19

Use a 50/50 mixture of clean,
drinkable water and DEX-COOL
coolant. If using this mixture,
nothing else needs to be added.
This mixture:

Gives freezing protection down
to

−

37°C (

−

34°F), outside

temperature.

Gives boiling protection up to
129°C (265°F), engine
temperature.

Protects against rust and
corrosion.

Will not damage aluminum parts.

Helps keep the proper engine
temperature.

{

Caution

If improper coolant mixture,
inhibitors, or additives are used in
the vehicle cooling system, the
engine could overheat and be
damaged. Too much water in the

(Continued)

Caution (Continued)

mixture can freeze and crack
engine cooling parts. The repairs
would not be covered by the
vehicle warranty. Use only the
proper mixture of engine coolant
for the cooling system. See

Never dispose of engine coolant by
putting it in the trash, pouring it on
the ground, or into sewers, streams,
or bodies of water. Have the coolant
changed by an authorized service
center, familiar with legal
requirements regarding used
coolant disposal. This will help
protect the environment and your
health.

Checking Coolant

The vehicle must be on a level
surface when checking the coolant
level.

Check to see if coolant is visible in
the coolant recovery tank. If the
coolant inside the coolant recovery
tank is boiling, do not do anything
else until it cools down. If coolant is
visible but the coolant level is not at
or above the COLD FILL mark, add
a 50/50 mixture of clean, drinkable
water and DEX-COOL coolant at the
coolant recovery tank, but be sure
the cooling system is cool before
this is done.

The coolant recovery tank cap has
this symbol on it.

When the engine is cold, the coolant
level should be at or above the
COLD FILL mark. If it is not, there
could be a leak in the cooling
system.