Инструкция для GMC SIERRA 1500 (2015)

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

Black plate (29,1)

GMC Sierra Owner Manual (GMNA Localizing-U.S/Canada/Mexico-

7299746) - 2015 - CRC - 6/5/14

Driving and Operating

9-29

Carefully remove the wire tie
that bundles the electrical plug.
Do not cut the electrical cord.

3. Plug the cord into a normal,

grounded 110-volt AC outlet.

{

Warning

Plugging the cord into an
ungrounded outlet could cause an
electrical shock. Also, the wrong
kind of extension cord could
overheat and cause a fire. You
could be seriously injured. Plug
the cord into a properly grounded
three-prong 110-volt AC outlet.
If the cord will not reach, use a
heavy-duty three-prong extension
cord rated for at least 15 amps.

4. Before starting the engine, be

sure to unplug and store the
cord as it was before to keep it
away from moving engine parts.
If you do not, it could be
damaged.

The length of time the heater should
remain plugged in depends on
several factors. Ask a dealer in the
area where you will be parking the
vehicle for the best advice on this.

Shifting Into Park

{

Warning

It can be dangerous to get out of
the vehicle if the shift lever is not
fully in P (Park) with the parking
brake firmly set. The vehicle can
roll. If you have left the engine
running, the vehicle can move
suddenly. You or others could be
injured. To be sure the vehicle will
not move, even when you are on
fairly level ground, use the steps
that follow. With four-wheel drive,
if the transfer case is in
N (Neutral), the vehicle will be
free to roll, even if the shift lever
is in P (Park). Be sure the transfer

(Continued)

Warning (Continued)

case is in a drive gear. If towing a
trailer, see

Driving Characteristics

and Towing Tips on page 9-69

1. Hold the brake pedal down, then

set the parking brake.

See

Parking Brake on

page 9-47

2. Move the shift lever into the

P (Park) position by pulling the
shift lever toward you and
moving it up as far as it will go.