Инструкция для GMC TERRAIN (2014)

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

Black plate (20,1)

GMC Terrain/Terrain Denali Owner Manual (GMNA-Localizing-U.S./Canada/

Mexico-6081485) - 2014 - CRC - 12/6/13

9-20

Driving and Operating

Caution (Continued)

breaking-in guideline every
time you get new brake
linings.

Following break-in, engine speed
and load can be gradually
increased.

Ignition Positions

The ignition switch has four different
positions.

{

Caution

Using a tool to force the key to
turn in the ignition could cause
damage to the switch or break the
key. Use the correct key, make
sure it is all the way in, and turn it
only with your hand. If the key
cannot be turned by hand, see
your dealer.

The key must be fully extended to
start the vehicle.

To shift out of P (Park), turn the
ignition to ON/RUN and apply the
brake pedal.

1 (STOPPING THE ENGINE/LOCK/
OFF):

When the vehicle is stopped,

turn the ignition switch to LOCK/
OFF to turn the engine off. Retained
Accessory Power (RAP) will remain
active. See

Retained Accessory

Power (RAP) on page 9-23

This locks the steering wheel,
ignition and automatic transmission.

This is the only position from which
the key can be removed. If the can
cannot be removed, make sure the
shift lever is in P (Park).

The ignition switch can bind in the
LOCK/OFF position with the wheels
turned off center. If this happens,
move the steering wheel from right
to left while turning the key to ACC/
ACCESSORY. If this does not work,
then the vehicle needs service.

Do not turn the engine off when the
vehicle is moving. This will cause a
loss of power assist in the brake
and steering systems and disable
the airbags.

If the vehicle must be shut off in an
emergency:

1. Brake using a firm and steady

pressure. Do not pump the
brakes repeatedly. This may
deplete power assist, requiring
increased brake pedal force.

2. Shift the vehicle to N (Neutral).

This can be done while the
vehicle is moving. After shifting