![background image](/i/gorenje/145650/gorenje-vck2203rcyiii/h/gorenje-vck2203rcyiii-022.png)
22
Fit a nozzle to telescopic tube:
-
Floor brush is intended for cleaning
bare floor and floor coverings.
-
Crevice/furniture nozzle is for cleaning
corners and between cushions.
According to the mark rotate the nozzle
to brush position to clean curtain or dust
on the decorating surfaces.
Instruction for use
Before using the appliance, unwind a
sufficient length of cord and insert the plug
into the power supply.
Press the On/Off button to switch the unit on.
To stop it press the On/Off button again.
You can adjust the air flow using the air flow
regulator on the flexible hose:
-
decrease power for cleaning curtains,
books, furniture, etc.
-
increase power for cleaning bare floor.
To rewind the cord, press the rewind button and
guide the cord with hand to ensure that it does
not whip causing damage.
Maintenance
1. Spilling rubbish from the dust
compartment subassembly
Always operate the cleaner with the dust
compartment subassembly whole installed.
If you forget to attach HEPA and filter or
attach its in the wrong manner, the dust
compartment subassembly may not rinse.
1. After removing the flexible tube, press the
locking buttons to open the cover.
2. Carry the dust compartment subassembly.
3. Carry away the dust-glass cap and Spill
rubbish.
4. Spill rubbish and fix the dust compartment
subassembly.
5. Replace the dust compartment subassembly
until it is locked.
2. CLEANING AND CHANGING
FILTER
We Filter for air-inlet should be cleaned at
least twice a year or when it becomes
visible solid.
We suggest to clean HEPA filter after every
long use.
With regular cleaning and maintenance of
HEPA filter, you will achieve good results of
cleaning, and hence the longer life of the
appliance.
To achieve this we recommend the following
cleaning methods:
-
Cleaning with brush,
-
Shaking the dust from filter,
-
Cleaning the dust from HEPA with
compressed air.
Clean HEPA filter provides a smooth air
flow and allows optimal suction power.
3. CHANGING THE OUTLET HEPA
FILTER
1. Open the grille for air-outlet.
2. When open the grille for air-outlet, the filter
for air-outlet is found.
3. Take the filter out and change a clean one.
4. Close the grille for air-outlet.
Floor Brush
Extension Tube