NOTE:
Some options may not be integrated at the factory. To ensure only valid configurations are ordered, HP
recommends the use of an HP approved configurator. Contact your local sales representative for additional information.
HP Unique Options
HP ML150 Gen9 4LFF Hot Plug Drive Cage
NOTE:
Adding 4LFF Hard Drive Cage allow up to 8FF Drive Bays.
725872-B21
HP ML150 Gen9 8SFF Hot Plug Drive Cage
NOTE:
Adding 8SFF Hard Drive backplane allow up to 16SFF Drive Bays.
725874-B21
HP ML150 Gen9 4LFF Non-hot Plug Drive Cage
NOTE:
Adding 4LFF Hard Drive Cage allow for up to 8LFF Drive Bays.
779859-B21
HP ML150 Gen9 PCI Baffle Kit
NOTE:
Must select when a PCIe card is installed with any Networking,
Controllers (SAS, SCSI and Fiber Channel), Graphic options.
779861-B21
HP ML150 Gen9 Slim ODD Enablement Kit
NOTE:
Must select with the ODD option.
784603-B21
HP ML150 Gen9 Smart Storage Battery Holder Kit
NOTE:
Must select when install Smart Store Battery PN: 727258-B21.
NOTE:
Must select when install P440/840 FIO controller PN: 761872-
B21/761874-B21.
NOTE:
Must select when support upgrade battery.
786710-B21
HP ML150 Gen9 9/10LFF Drive Enablement Kit
NOTE:
When populate 10 LFF, not able to install any Tape Drive or Optical
Drive. Possible Configurations: 1) 8LFF +1 ODD + 1 Tape Drive (Full/Half), or 2)
9LFF + 1 ODD, or 3) 9LFF + 1 Tape Drive (Full/Half).
NOTE:
Must select both 4LFF NHP drive cage and 10LFF enablement kit if plan
to expand to 10LFF.
NOTE:
Only support NHP SATA HDD.
NOTE:
Must select P840/4G controller.
788567-B21
HP ML150 Gen9 Dedicated iLO Management Port Kit
780310-B21
HP ML150 Gen9 Mini SAS H240 Cable Kit
NOTE:
Must be selected for H240 controller.
1 cable kit is required for Hot Plug 4LFF.
2 cable kits are required for below:
- Hot Plug 4+4 LFF (with additional drive cage)
- 8SFF
784606-B21
HP ML150 Gen9 Mini SAS P440/P840 Cable Kit
NOTE:
Must be selected for P440/P840 controller.
1 cable kit is required for P440x1.
2 cable kits are required for P840x1.
784608-B21
HP Tower to Rack Conversion Tray Universal Kit
417705-B21
HP AHCI-Enable FIO Setting
NOTE:
This needs to be selected when Advanced Host Controller Interface
mode is required on B140i controller.
801845-B21
QuickSpecs
HP ProLiant ML150 Generation9 (Gen9)
Core Options
DA - 15090 Worldwide QuickSpecs — Version 1 — 12.1.2014
Page 20