QuickSpecs
HP Z440 Workstation
System Technical Specifications
c04400038 — DA - 15098 Worldwide — Version 7 — April 1, 2015
Page 17
Supported Drive Interfaces
SATA
2 SATA @6Gb/s, supports RAID 0,1 and NCQ.
4 sSATA @6Gb/s, Supports RAID 0,1,10 and NCQ.
Factory integrated RAID is Microsoft Windows only.
Serial Attached SCSI
Requires Optional PCIe card
Integrated RAID
SATA: RAID 0, 1
SSATA: RAID 0, 1, 10
• RAID 0 configuration - striped array (supported and configure to
order)
• RAID 1 configuration - mirrored array (supported and configure to
order)
• RAID 5 parity striping (supported but not configure to order)
• RAID 10 striped and mirrored array
*HW RAID functionality not supported by Linux. Use SW RAID
functionality provided in the Red Hat Operating system instead.
Integrated Graphics
No
Network Controller
Integrated Intel I-218 Gbit LAN
Supports the following management functionalities: Intel AMT9.1,
TXT, DASH 1.1, WOL, VLAN, Teaming and PXE 2.1
External SATA (eSATA)
Supported on all SATA and sSATA ports configurable with optional
eSATA* cable kit
* hot plug / hot swap not supported with eSATA
IDE connector
No
Floppy connector
No
Serial
1 internal header
2nd Serial
No
Parallel
No
AUX IN (audio)
No
IEEE 1394 Connector(s)
Front
None
Rear
2 IEEE 1394b (requires optional PCIe card)
Internal
None
USB Connector(s)
Front
4 USB 3.0
Rear
4 USB 3.0
2 USB 2.0
Internal
2 USB 2.0 port available with a single 2x5 header. The 2x5 header
can be converted to a standard (Type-A) USB connector through the
use one HP Internal USB Port Kit (EM165AA). This port kit uses one