14

GB

DATA PLATE 

Dimensions 

width cm 43.5 
height cm 32 
depth cm 40 

Volume 

lt. 56 

Electrical 
connections 

voltage: 220-230V ~ 50/60 Hz or 
50Hz  (see data plate) 
maximum power absorbed 2250W

Directive 2002/40/EC on the label 
of electric ovens.  
Standard EN 50304 
 

ENERGY LABEL 

Models with cooling ventilation: 

Energy consumption for Natural 
convection heating mode:         
Convection 
Declared energy consumption for 
Forced convection Class heating 
mode:              Multi-cooking 

 
Models without cooling 
ventilation:

Energy consumption for Forced 
convection heating mode:        
Multi-cooking 
Declared energy consumption for 
Natural convection Class heating 
mode:             Convection 

This appliance conforms to the 
following European Economic 
Community directives:  
2006/95/EEC of 12/12/06 (Low 
Voltage) and subsequent 
amendments; 
-2004/108/EEC of 15/12/04 
(Electromagnetic Compatibility) and 
subsequent amendments; 
93/68/EEC of 22/07/93 and 
subsequent amendments. 
2002/96/EC and subsequent 
amendments. 

Electrical connections

!

 Ovens equipped with a three-pole power supply

cable are designed to operate with alternating current
at the voltage and frequency indicated on the data
plate located on the appliance (

see below).

Fitting the power supply cable

1. Open the terminal
board by inserting a
screwdriver into the
side tabs of the cover.
Use the screwdriver as
a lever by pushing it
down to open the cover
(

see diagram).

2. Loosen the cable
clamp screw and
remove it, using a

screwdriver as a lever
(see figure).

3. Remove the wire
contact screws L-N- 
, then fasten the wires
under the screw heads,
respecting the colour
code: Blue (N), Brown
(L) and Yellow-Green
Verde (

).

Connecting the supply cable to the mains

Install a standardised plug corresponding to the load
indicated on the data plate (

see side).

The appliance must be directly connected to the
mains using an omnipolar circuit-breaker with a
minimum contact opening of 3 mm installed between
the appliance and the mains, suitable for the load
indicated and complying with current electrical
regulations (the earthing wire must not be interrupted
by the circuit-breaker). The supply cable must not
come into contact with surfaces with temperatures
higher than 50°C.

!

 The installer must ensure that the correct electrical

connection has been made and that it is compliant
with safety regulations.

Before connecting to the power supply, make sure
that:

• The appliance is earthed and the plug is compliant

with the law.

• The socket can withstand the maximum power of

the appliance, which is indicated on the data plate
(

see below).

• The voltage must be in the range between the

values indicated on the data plate (

see below).

• The socket is compatible with the plug of the

appliance. If the socket is incompatible with the
plug, ask an authorised technician to replace it. Do
not use extension cords or multiple sockets.

!

 Once the appliance has been installed, the power

supply cable and the electrical socket must be easily
accessible.

!

 The cable must not be bent or compressed.

!

 The cable must be checked regularly and replaced

by authorised technicians only (

see Assistance).

! The manufacturer declines any liability should
these safety measures not be observed.