![background image](/i/infiniti/149357/infiniti-fx35-2008-fx45-2008/h/infiniti-fx35-2008-fx45-2008-154.png)
4. Push the SET switch and, within 5 sec-
onds, push the memory switch (1 or 2)
fully for at least 1 second.
The indicator light for the pushed memory
switch will come on and stay on for ap-
proximately 5 seconds after pushing the
switch. After the indicator light goes off,
the selected positions are stored in the
selected memory (1 or 2).
If a new memory is stored in the same
memory switch, the previous memory will
be deleted.
Linking a keyfob or Intelligent Key
to a stored memory position
A keyfob or Intelligent Key can be linked
to a stored memory position with the fol-
lowing procedure.
1. Follow the steps for storing a memory
position.
2. While the indicator light for the
memory switch being set is illumi-
nated for 5 seconds, press the
button on the keyfob or Intelli-
gent Key. The indicator light will blink.
After the indicator light goes off, the
keyfob or Intelligent Key is linked to
that memory setting.
With the key removed from the ignition
switch, press the
button on the
keyfob or Intelligent Key. The driver’s
seat, steering wheel and outside mirrors
will move to the memorized position.
Confirming memory storage
O
Turn the ignition ON and push the SET
switch. If the main memory has not
been stored, the indicator light will
come on for approximately 0.5 second.
When the memory has stored the posi-
tion, the indicator light will stay on for
approximately 5 seconds.
O
If the battery cable is disconnected, or
if the fuse opens, the memory will be
canceled. In such a case, reset the de-
sired positions using the following
procedures.
1. Open and close the driver’s door more
than two times with the ignition key in
the LOCK position.
2. Reset the desired position using the
previous procedure.
Selecting the memorized position
1. Set the selector lever to the P (Park)
position.
2. Use one of the following methods to
move the driver’s seat, steering
column and outside mirrors.
O
Turn the ignition switch to the ON po-
sition and push the memory switch (1
or 2) fully for at least 1 second.
O
Within 45 seconds after opening the
driver’s door, push the memory switch
(1 or 2) fully for at least 1 second.
The driver’s seat, steering column and
outside mirrors will move to the memo-
rized position with the indicator light
flashing, and then the light will stay on
for approximately 5 seconds.
ENTRY/EXIT FUNCTION
This system is designed so that the driv-
er’s seat, steering column and door mir-
rors will automatically move when the au-
tomatic transmission selector lever is in
the P (Park) position. This allows the
driver to get into and out of the driver’s
seat more easily.
3-32
Pre-driving checks and adjustments
w
07.11.30/S50-D/V5.0
X