![background image](/i/infiniti/150541/infiniti-m45-2010/h/infiniti-m45-2010-327.png)
Sensor maintenance
The sensor for the ICC system
s
A
is located
below the front bumper.
To keep the ICC system operating properly, be
sure to observe the following:
●
Always keep the sensor clean. Wipe with a
soft cloth carefully so as not to damage the
sensor.
●
Do not strike or damage the areas around
the sensor. Do not touch or remove the
screw located on the sensor. Doing so could
cause failure or malfunction. If the sensor is
damaged due to an accident, contact an
INFINITI retailer.
●
Do not attach a sticker (including transpar-
ent material) or install an accessory near the
sensor. This could cause failure or malfunc-
tion.
CONVENTIONAL (FIXED SPEED) CRUISE
CONTROL MODE
This mode allows driving at a speed between 25
to 89 MPH (40 to 144 km/h) without keeping
your foot on the accelerator pedal.
WARNING
●
In the conventional (fixed speed) cruise con-
trol mode, a warning chime does not sound
to warn you if you are too close to the vehicle
ahead, as neither the presence of the vehicle
ahead nor the vehicle-to-vehicle distance is
detected.
●
Pay special attention to the distance be-
tween your vehicle and the vehicle ahead of
you or a collision could occur.
●
Always confirm the setting in the Intelligent
Cruise Control system display.
●
Do not use the conventional (fixed speed)
cruise control mode when driving under the
following conditions:
– when it is not possible to keep the vehicle
at a set speed
– in heavy traffic or in traffic that varies in
speed
– on winding or hilly roads
– on slippery roads (rain, snow, ice, etc.)
– in very windy areas
●
Doing so could cause a loss of vehicle control
and result in an accident.
Type A
SSD0676
Type B
SSD0695
5-42
Starting and driving
w
—
—
05/15/09—pattie
X