0~255
Pr.01
1~30
140-167(GB)
0~255
168-195(B)
196-223(RB)
224-251(RB)
252-255(RGB)
Pr.02
31-61
0~255
Pr.03
62-92
Pr.04
93-123
Pr.05
124-154
Pr.06
155-185
Pr.07
186-216
Pr.08
217-247
Pr.09
248-255
5. Static Color Mode
This mode is dimming mode, press “MODE” button for more than 2s to dim the static color, press UP and DOWN
buttons could set r.000~r.255, g.000~255, b.000~b.255, u.000~u.255.
6. Power Charge Mode
This mode is available when battery is charging.
Press the “MODE” button for more than 2s to see the power percentage 0~100.
C. Lithium Battery & Wireless use Instruction
Our product is equipped with Wireless receptor. If you use this fixture to be a master, you need to use a transmitter
to replace the receptor. Our product has Power and memory function, it will keep in touch with last transmitter. So,
you need to stop the transmitter operation when you use a new transmitter. Please see below operation instruction.
1.
The battery is 14.8V, 7800mAh which is brand of 18650 Lithium Battery. It will take 6.5 hours to be fully
charged and it can be use for 5.5 hours. Please operate this product in the right way and discharge it. Please
don’t let the fixture spare for long time, should use and charge time by time.
2.
The battery capacity display will show the product is on, fully charge or low battery. While you are using it and
charging it, the fixture will be turned off and it is fully charge. The five LED instruct lights respect the battery is
100%~80%, 60%, 40%, 20%, 20%~0%. Please charge the fixture timely when the red LED instruct light flash
because it means the battery is less than 20%.
3.
The wireless band of this product is 2.4G Hz, and the address can be searched auto. The green LED instruct
light is wireless single instruct light, it will stay in below status:
1)
If the light bright for 900 millisecond and dark for 900 millisecond, it means the fixture is connected with
transmitter but without wireless single.
2)
If the light keep brighten, it means the fixture is connected with the transmitter and has wireless single.
3)
If the light bright for 100 millisecond and dark for 100 millisecond, it means the fixture is trying to connect with
transmitter or losing the single.
4)
If the light keep darken, it means the fixture isn’t connected with any transmitter.
4.
When you need to stop the fixture to connect with transmitter and the display is bright, please press “MODE”
and “DOWN” button more than 2 seconds. Then, the fixture will not connect with the transmitter and the green
light will be turned off.
