5. Master/slave Mode
Press the “MODE”, the LED display will show as below, enter LED slave mode.
C. System Options
In any state, long press the “SETUP”, enter the main interface of the system options:
Lightly press the “SETUP”, select the temperature protection switch options, PCB temperature inquires, LED
biggest gray, restore factory settings.
Setting details as below sheet:
Temperature
control
switch
options
Press UP, will show
, open temperature control.
Press DOWN, will show
, closed temperature.
PCB
temperature
options
Press DOWN or UP update temperature
,the current
temperature is 33
℃
LED biggest
gray value
Press DOWN or UP update the LED newest brightness
(0—255).
Restore
factory
setting
Press UP to restore factory settings
On system options, lightly press the “MODE”, return to the system main interface
, press the “MODE”
again, return before LED mode menu.
D. Restore Factory Settings
There are two kinds of methods to restore factory settings.
1) In menu system options
, press the “UP” to restore factory settings.
2) When in power failure situation, press the “MODE” and “SETUP”, power on to restore factory settings.
