4

IMPORTANT!OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including calculating 

working load limits, installation material being used, and periodic safety inspection of all installation 

material and the projector. If you lack these qualifications, do not attempt the installation yourself, but 

instead use a professional structural rigger. Improper installation can result in bodily injury and or 

damage to property. The projector had to be installed out of the reach of people 

DANGER OF FIRE! When installing the device, make sure there is no highly-inflammable 

material(decoration articles, etc.)within a distance of min.0.5m. 

DMX 512 connection/ connection between fixture 

The wires must not come into contact with each other, otherwise the fixture will not work at all or 

properly. Please note the starting address depends upon which controller is being used. Only use a 

DMX cable and 3-pin XLR-plugs and connectors in order to connect the controller with the fixture or one 

fixture to another   

Connection with the mains.   

The earth has to be connected. The device must only be connected with an electric installation carried 

out in compliance with IEC standards.   

OPERATION 

After you connected the effect to the mains, The fixture starts running 

Stand Alone operation 

In the stand alone mode, the fixture can be use without controller 

Master/slave-operation 

The master/slave-operation enables that several devices can be synchronized and controlled by one 

master-device  

DMX controlled operation 

You can control the projectors individually via your DMX-controller 

Addressing 

The control board allows you to assign the DMX starting address,