Инструкция для KARCHER HDS 8/17 CX

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

– 5

Caution

Risk of injury!

–

Use Kärcher products only.

–

Under no circumstances fill solvents
(petrol, aceton, diluting agent etc.)

–

Avoid eye and skin contact.

–

Observe safety and handling instruc-
tions by the detergent manufacturer.

Kärcher offers an individual cleaning
and care appliances program.

Your dealer will consult you gladly.



Refill detergent.

For connection values refer to technical
specifications



Connect the supply hose (minimum

length 7.5 m, minimum diameter 3/4“) to

the water connection point of the ma-

chine and at the water supply point (for

e.g. a tap).

Note:

The supply hose is not included.

If you want to suck in water from an exter-
nal vessel, the following modification is
necessary:



Remove the system care bottle.

Figure 9



Remove the two screws on the burner
casing.

Figure 10



Unscrew the back wall and remove it.
The nozzle of the system care reservoir
will remain in the back wall.

Figure 11



Remove water connection from the fine
filter.



Unscrew the fine filter from the pump
head.



Remove the system care reservoir.

Figure 12



Unscrew the top supply hose to the
swimmer container.



Connect the top supply hose at pump
head.



Replug the rinse line of the detergent
dosing valve to blind plugs.



Connect suction hose (minimum diame-
ter 3/4“) with filter (accessory) to the
water connection point.

–

Max. suck height: 0.5 m

Until the pump sucked in water, you should:



Set the pressure/quantity regulation at
the pump unit to maximum quantity.



Close the dosing valve for the deter-
gent.



Danger

Never suck in water from a drinking water
container. Never suck in liquids which con-
tain solvents like lacquer thinner, petrol, oil
or unfiltered water. The sealings within the
device are not solvent resistant. The spray
mist of solvents is highly inflammable, ex-
plosive and poisonous.



Assembly in reverse order.

Note:

Ensure that the solenoid valve cable

on the reservoir of the system care is not
pinched.

Figure 13
Note:

After placing the back wall, reach into

the chute of the system care and press the
nozzle onto the system care reservoir.

–

For connection values, see technical
data and type plate.

–

The electrical connections must be
done by an electrician according to IEC
60364-1.



Danger

Danger of injury by electric shock.

–

Unsuitable extension cables can be
hazardous. Only use extension cables
outdoors which have been approved for
this purpose and labelled with a suffi-
cient cable cross section:

–

Always unwind extension lines com-
pletely.

–

The plug and coupling of the extension
cable used must be watertight.

Refill detergent

Water connection

Suck in water from vessel

Power connection