-
8
Î
Raise the sweeper from the front and
drive it on to a smooth, even surface
covered with a visible layer of dust or
chalk.
Î
Lock parking brake.
Î
Let the sweeping roller rotate for ap-
prox. 15-30 seconds.
Î
Raise the sweeper at the front and drive
it towards the side.
The sweeping track should have an even
rectangular shape which is between 30 and
40 mm wide.
Adjust sweeping track width, Com-
fort model
Note:
If the sweeping track is too small and
the Bowden cable is tensioned when the
roller brush is lowered, the Bowden cable
must be adjusted.
Î
Adjust sweeping track on Bowden cable.
Î
Check sweeping mirror.
Adjust sweeping track width, Classic
model
1 Rotary knob
Î
Turn the rotary knob:
– In clock-wise direction: Sweeping track
becomes smaller
– Anti-clockwise direction: Sweeping
track becomes bigger
Î
Check sweeping mirror.
Replacement is due if a visible deteriora-
tion in sweeping performance caused by
bristle wear is evident.
Î
Comfort model: Rotate push handle
clock in an anti-clockwise direction.
Lock has been unlocked.
Î
Remove the waste container.
Î
Push appliance to the back onto the
push handle.
Î
Unscrew 3 screws from the underside
of the side brush.
Î
Remove the wiper blade.
Î
Clip new side brushes on to driver and
screw on.
Î
Tilt the appliance forward.
Adjustment is necessary if a visible deterio-
ration in sweeping performance caused by
side-brush is evident.
Î
Loosen counter-nut.
Î
Adjust the adjustment screw.
Î
Tighten the counter-nut.
– Adjustment is necessary if the bulk
waste flap cannot be raised wide
enough.
– The Bowden cable needs to be re-
leased a little if the sweeper results be-
come poorer, for e.g. due to the wearing
of the front lip.
Î
Loosen counter-nut.
Î
Adjust the adjustment screw.
Î
Tighten the counter-nut.
If the sweeping results degrade due to the
wear of the sealing strips, the sealing strips
must be readjusted or replaced.
Î
Comfort model: Rotate push handle
clock in an anti-clockwise direction.
Lock has been unlocked.
Î
Remove the waste container.
Î
Push appliance to the back onto the
push handle.
Front sealing strip
Î
Loosen the fastening screws of the
sealing strip.
Î
Readjust the sealing strips pushing
them downward into the slot.
Î
Tighten the fastening screws of the
sealing strip.
Î
Prepare the appliance and move it a
small distance forwards.
Î
Set the distance between the sealing
strip and the floor so that the bottom
edge trails behind at a distance of be-
tween 10 and 15 mm.
Note:
If the setting range is not sufficient,
the sealing strip is worn off and should be
replaced.
Rear sealing strip
Check and adjust roller brush sweeping
track
Replacing side brush
Adjust side-brush lowering
Adjust the raising of the bulk waste flap
Adjusting and replacing sealing strips
21
EN