![background image](/i/lg/157575/lg-lvs311/h/lg-lvs311-010.png)
10
Introduction
e
RESET button
Push the button more than 3 seconds, this would restore the factory default settings.
f
RS-485/RS-422 Dip Switch
The default position of the dip switch and function are as shown below.
Position
SW1
SW2
SW3
SW4
ON
RS-485
RS-485 HALF
TERMINATION ON
OFF
RS-422
RS-485 FULL
TERMINATION OFF
g
VIDEO OUT
Supplies analog video signal (composite) to the connected device.
h
AUDIO OUT (Line Level Output)
Connect to an active speaker with a built-in amplifier.
i
AUDIO IN (Line Level Input)
Input for a mono microphone, or a line-in mono signal.
j
ETHERNET/POE Port
Connects to a PC or a network via a hub with a 10 BASE-T/100 BASE-TX cable attached RJ-45 connector.
Note:
Power over Ethernet (PoE) is a technology that integrates power into a standard LAN infrastructure. It enables power to be provided
to the network device, such as a network camera, using the same cable as that used for network connection. It eliminates the need
for power outlets at the device locations and enables easier application of uninterruptible power supplies (UPS).
k
Power input terminal
Connects to a DC 12 V or AC 24 V power supply using proper cables.