Инструкция для Lincoln MKZ Hybrid (2013)

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

E142658

1. With your vehicle parked outside

of the garage, turn your ignition to
the

position, but do not start

your vehicle.

2. Hold your hand-held garage door

transmitter 1–3 inches (2–8
centimeters) away from the
HomeLink button you want to
program.

3. Using both hands, simultaneously,

press and hold the desired
HomeLink button and the
hand-held transmitter button. DO
NOT release either one until the
HomeLink indicator light flashes
slowly and then rapidly. When the
indicator light flashes rapidly, both
buttons may be released. The
rapid flashing indicates successful
training.

4. Press and hold the HomeLink

button you programmed for five
seconds, then release. You may
need to do this twice to activate
the door. If your garage door does
not operate, watch the HomeLink
indicator light.

If the indicator light stays on, the
programming is complete. See

Programming your garage door
motor

later in this section.

If the indicator light flashes rapidly for
2 seconds and then turns to a
constant light, the HomeLink button
is not programmed yet. Do the
following:

Press and hold the HomeLink button
while you press and release the
hand-held transmitter button every 2
seconds. The HomeLink indicator light
will flash slowly and then rapidly once
the HomeLink function button
recognizes and accepts the hand-held
transmitter’s radio frequency signal.

After programming the HomeLink
button, begin programming your
garage door opener motor.

Note:

You may need a ladder to reach

the unit and you may need to remove
the cover or lamp lens on your garage
door opener.

E142659

To program additional buttons, repeat
Steps 1 – 4.

For questions or comments, please
contact HomeLink at
www.homelink.com or
1-800-355-3515.

154

MKZ (CC9)

Universal Garage Door Opener