Инструкция для Lincoln Navigator (2007)

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

1. The ignition must be OFF to
begin the sequence.

2. Place the key in the ignition and
turn the ignition to the 3 (RUN)
position.

3. Press the power door unlock
control on the door panel three
times.

4. Turn the ignition from the 3 (RUN) position to the 1 (LOCK) position.

5. Press the power door unlock control on the door panel three times.

6. Turn the ignition back to the 3 (RUN) position. The horn will chirp
one time to confirm programming mode has been entered and is active.

7. Press the power door unlock control twice within 5 seconds.

Note:

The horn will chirp once to indicate the perimeter lighting feature has
been deactivated. The horn will chirp once and honk once (one short
and one long) to indicate the perimeter lighting feature has been
activated.

8. Turn the ignition to the 1 (LOCK) position to exit the procedure.

Note:

The horn will chirp once to confirm the procedure is complete.

KEYLESS ENTRY SYSTEM

You can use the keyless entry keypad to:

•

lock or unlock the doors without using a key,

•

activate or deactivate the Autolock feature if equipped

•

release the liftgate glass,

The keypad can be operated with the factory set 5–digit entry code; this
code is located on the owner’s wallet card in the glove box and is
available from your authorized dealer. You can also create your own
5–digit personal entry code.

When pressing the controls on the keyless entry keypad, press the
middle of the controls to ensure a good activation.

Programming your own personal entry code

To create your own personal entry code:

1. Enter the factory set code.

2007 Navigator

(nav)

Owners Guide (post-2002-fmt)
USA

(fus)

Locks and Security

129