-

 12 

-

4.4   Flap control

Control the flap by AIRFLOW button on the wireless remote controller.

(1)

Air scroll

The flap will be automatically set to the angle of air flow best to operation.

(a)

Starting time of operation

(b)

When not operating

The flap returns to the position of air flow directly below, when operation has stopped.

(2)

Memory flap

While the flap is operating if the AIRFLOW button is pushed once, it stops swinging at an angle.

As this angle is memorized in the microcomputer, the flap will be automatically set to the angle when next operation is started.

¡

Recommendable stopping angle of the flap

(3)

Swing flap

Flap moves in upward and downward directions continuously.

s

During cooling and

t

dry operation

Thick line                : Rapid movement

Thin line                  : Slow movement

Stops for approximately
5 seconds in the
horizontal position.

s

During heating

t

operation

Stops for approximately
5 seconds in this
position.

Thick line                : Rapid movement

Thin line                  : Slow movement

Horizontal
blowing

COOL•DRY

Slant forward
blowing

HEAT

Corrects the starting time of next operation by
calculating the temperature difference.

(Example) Heating

Setting temperature

Room temperature

Operation starting time

Time

Setting time

15 min.

10 min.

5 min.

earlier

earlier

earlier

¡

If the difference (= Setting temperature – Room tempera-
ture) is 4ºC, the correction value is found to be +5 min-
utes from the table shown above so that the starting time
of next operation is determined as follows:

15 min. earlier + 5 min. = 20 min. earlier

↑

↑

Current operation

Correction value

start time

4.5   Comfort timer setting

If the timer is set at ON when the operation select switch is set at the cooling or heating, or the cooling or heating in auto mode operation

is selected, the comfort timer starts and determines the starting time of next operation based on the initial value of 15 minutes and the

relationship between the room temperature at the setting time (temperature of room temperature thermistor) and the setting temperature.

(Max. 60 minutes)

Operation mode

Operation start time correction value (Min.)

3 < Room temp. – Setting temp.

1 < Room temp. – Setting temp. 

≤

 3

Room temp. – Setting temp. 

≤

 1

At cooling

+5

No change

–5

3 < Setting temp. – Room temp.

2 < Setting temp. – Room temp. 

≤

 3

Setting temp. – Room temp. 

≤

 2

At heating

+5

No change

–5

Notes (1) At 5 minutes before the timer ON time, operation starts regardless of the temperature of the room temperature thermistor (Th1).

(2) This function does not actuate when the operation select switch is set at the dehumidifying as well as the dehumidifying in the auto mode.

However, the operation of item (1) above is performed during the dehumidifying in the auto mode.

(3) During the pleasant reservation operation, both the operation lamp and timer lamp illuminate and the timer lamp goes off after expiration of the timer, ON setting

time.

=

=

=

=

Опубликовано TopClimat