PREPARATION
1.Installing batteries/Connecting the AC adaptor
Batteries
Battery Remove the battery compartment
compartment cover and insert six batteries(R6P/LR6
/AAsize) into the battery compartment,
use extreme care that the polarities
plus and minus are correct. BE
CAREFULL Not to push on the tray!
(Overload / Damage can occur)
R6P/LR6/AA size
Battery compartment cover Dry batteries.
(use high powered batteries only)
AC adapter (optional)
Plug the AC adapter to the AC
AC adaptor
adapter socket on the side.
socket
The AC input requirement could
be 100,120,220,230 or 240Volts
(50/60Hz) depending on the area
where used, so please verify that
the adaptor is correct
2.Setting up the i101
△
!
CAUTION
Avoid placing the scale in direct sunlight, this may cause discoloration or
malfunction. Place your i101 on a firm weighing table so that the scale is level.
(The scale will not perform accurately when it is not level.) Make sure there are
absolutely
NO
air currents or vibrations. They can cause inaccurate readings.
Place the i101 on a firm surface that is flat and level for accurate weighing. Be
certain there is no cell or cordless phone interference and no vibrations.
3
WEIGHING
Before weighing
Whenever possible, please allow the scale to warm up for 30 seconds after first
turning the power on so that the scale will function properly and accurately.
Error messages
EEEE: Overload
: Low battery
Calibration may be required before weighing.
Calibration is rarely needed. Read "CALIBRATION" first and if necessary,
calibrate your scale for accurate weighing.
Weighing procedures
1.
Press [ON/OFF] to turn on the scale.
When the power is turned on, all display segments appear for a few seconds and "0"
will appear on the display.
2.
Select the weighing unit with [UNIT].
Press
[UNIT]
to select a weighing unit "g"
、
"oz"
、
"mg"
、
"ozt"
、
"dwt"
、
"ct"
、
"gn" or "pcs".
Once the unit has been selected, the selected unit will be displayed next to the
weight value.
3.
Start weighing
If you do not use a container for weighing,
Verify the reading is "0". If not, press
[ZERO]
to display "0".
Place objects on the weighing platform to weigh.
When the reading becomes stable, the stable indicator is displayed.
If you use a container for weighing,
Place an empty container on the platform.
Wait for the stability indicator to be displayed and press
[ZERO]
.
Place the objects to be weighed in the container.
When the reading becomes stable, the stable indicator is displayed.
4
