2.1 Cable tracing 

2.1.1)Open battery cover, install DC 9V battery in launcher,push the 
key of emitter to “scan”, the indicator flashes, which means the emitter 
is normal.   
2.1.2)Connect  the cable to be tested to  corresponding port.
2 . 1 . 3 )P u s h t h e k e y o f r e c e i v e r  t o “ S c a n ” , t h e i n d i c a t o r f l a s h e s , 
which means the emitter is normal. Then hold the receiver to trace 
cable.  
During operation, users can alter the volume gradually to ideal state.
Attention: 
1)If the cable to be traced is energized (

＜

60VDC) , users have to turn

the volume to degree 1-3.
2)If the cable to be traced is non-energized, users have to turn the 
volume to degree 6-8.  

2.2 Cable mapping

2.2.1)Connect network line to the RJ45 port of emitter and receiver 
separately.
2.2.2)Push the key of receiver  to “Test”, the indicator flashes, which 
means 

the emitter is normal.  then go ahead with the test result.  

(Note: users can press”SET” to choose the testing speed)
2.2.3)When the tested cable is in good connection, 
If UTP cable, No.1-8  leds will blink one by one  in circulation.

                     Emitter:   1-2-3-4-5-6-7-8
                     Receiver:1-2-3-4-5-6-7-8

If STP cable,  No. 1-8 &G leds will blink one by one  in circulation. 

                    Emitter:   1-2-3-4-5-6-7-8-G
                    Receiver:1-2-3-4-5-6-7-8-G

2.2.4)When the tested cable is not connected well
If No. 2 & No.3 cables are shorted, the No.2 & 3 Leds of receiver won’t 
be on, while No.1-8 leds of emitter is still on in circulation.
If No.2 cable  is open, the No.2 led of emitter and receiver  won’t be on.

2.Operations  

Your excellent helper in cable test!

2