![background image](/i/pentax/164612/pentax-af-540-fgz/h/pentax-af-540-fgz-049.png)
47
When you turn the camera on and press the
shutter release button halfway down, the
channel is registered on the camera.
Next, remove the flash unit from the camera and
place it in the desired position.
●
Press the flash mode button (MODE) to display
(P-TTL) if the flash mode was set to the modes
other than P-TTL.
Set the zoom position. (Refer to page 21)
●
Set the zoom position with (M.Zoom) regardless
of the lens you use.
Enable the built-in flash unit of the camera and
display (
) on the LCD panel.
Set the sync mode switch of the wireless flash
unit to leading curtain sync (
).
Set the exposure mode of the camera to manual
exposure and the shutter speed faster than X-
sync speed.
●
If the shutter speed is the same or slower than
the X-sync speed of the camera, the flash will be
set to P-TTL mode, and when it is faster than X-
sync speed, the flash will be set to high-speed
sync mode.
Confirm that the AF540FGZ and built-in flash unit
are fully charged, and take the photograph.
A lamp on the wireless flash unit will blink.
●
The built-in flash unit is used for control flash
only. It will not be used for main flash.
●
Refer to camera's operating manual for the
operation of the camera.
2
3
4
5
6
7
AF540FGZ_OPM_ENG.book Page 47 Friday, January 14, 2011 12:44 PM