![background image](/i/pioneer/164740/pioneer-deh-1000e/h/pioneer-deh-1000e-011.png)
Adjusting source levels
SLA (source level adjustment) lets you adjust
the volume level of each source to prevent ra-
dical changes in volume when switching be-
tween sources.
!
Settings are based on the FM volume level,
which remains unchanged.
!
The MW/LW volume level can also be ad-
justed with source level adjustments.
1
Compare the FM volume level with the
level of the source you wish to adjust.
2
Press AUDIO to select SLA.
3
Press
a
or
b
to adjust the source vo-
lume.
SLA +4
to
SLA
–
4
is displayed as the source
volume is increased or decreased.
#
To return to the normal display, press
BAND
.
Other Functions
Adjusting initial settings
Using the initial settings, you can customize
various system settings to achieve optimal per-
formance from this unit.
1
Press SOURCE and hold until the unit
turns off.
2
Press SOURCE and hold until function
name appears in the display.
3
Press FUNCTION to select one of the in-
itial settings.
Press
FUNCTION
repeatedly to switch be-
tween the following settings:
FM
(FM tuning step)
—
A-PI
(auto PI Seek)
—
AUX
(auxiliary input)
—
SAVE
(power save)
Use the following instructions to operate each
particular setting.
#
To cancel initial settings, press
BAND
.
#
You can also cancel initial settings by holding
down
SOURCE
until the unit turns off.
Setting the FM tuning step
Normally the FM tuning step employed by
seek tuning is 50 kHz. When AF or TA is on,
the tuning step automatically changes to 100
kHz. It may be preferable to set the tuning step
to 50 kHz when AF is on.
!
The tuning step remains at 50 kHz during
manual tuning.
1
Press FUNCTION to select FM.
2
Press
c
or
d
to select the FM tuning
step.
Press
c
to select
50
(50 kHz). Press
d
to se-
lect
100
(100 kHz).
Switching Auto PI Seek
The unit can automatically search for a differ-
ent station with the same programming, even
during preset recall.
1
Press FUNCTION to select A-PI.
2
Press
a
or
b
to turn the Auto PI seek
on or off.
Switching the auxiliary setting
It is possible to use auxiliary equipment with
this unit. Activate the auxiliary setting when
using auxiliary equipment connected to this
unit.
1
Press FUNCTION to select AUX.
2
Press
a
or
b
to turn the auxiliary set-
ting on or off.
Saving the battery consumption
Switching this function on enables you to save
the consumption of battery power.
!
Operations other than turning on the
source are not allowed when this function
is on.
Operating this unit
En
11
English
Section
02