![background image](/i/president/155824/president-pm-500-swf/h/president-pm-500-swf-014.png)
14
Scanning
The PM-500 SWF can scan the channels programmed into memory, see Pro-
gramming Scan Channels below.
To initiate scanning;
1. Assuming the unit is on CH17 when switched on.
2. Press
SCAN
and scanning starts.
SCAN
icon
appears during scanning.
The PM-500 SWF will scan memory channels in
ascending order.
If Triple Watch is turned on during scan then the
radio will scan the memory channels in ascending
order and will check channel 09 and channel 16 every 2 seconds, then resume
scanning the memory channels.
Programming Scan Channels
1. Select the channel you want to store by pressing
(
s
) or (
t
).
2. Press and hold
MEM
.
MEM
appears and a dou-
ble beep is heard.
3. To remove the channels from Memory, press and
hold
MEM
once more. A double beep sounds
and
MEM
disappears.
Drop-out Delay
While scanning, the PM-500 SWF stops at a busy channel and receives a
signal. When the received signal is over, the unit will wait for 2 seconds for the
return of the signal, otherwise, the radio resumes scanning.
Power Save
Battery Save feature extends the battery life by switching the receiver circuit
power ON and OFF. This feature automatically activates during standby mode
(RX mode without signal).