Warning: forbid to reverse connect polarity,
it will damage the inverter.
2.
Screw in terminal post, but not too tightly
3.
Connect the black clip to the negative pole of
battery; connect the red clip to the positive pole. If
it is too loosen, will result no current, wire heat, and
damage the power inverter or cause the fire.
4.
Turn on the power inverter; connect this device
with the applicant to be used.
5.
If you don’t use the power inverter, please
disconnect the wires.
WARNING:
1.
Before use, please confirm the input voltage of
inverter is matched to the output of car cigar plug,
and confirm the rated power of applicant within the
range of power inverter.
2.
When you get the power from car cigar plug,
please confirm the load power is less than 250
W, otherwise, the car external wire will burn out
because the over - heat.
3.
Do not use this device when engine is off,
otherwise, it may damage the car battery
4.
Please do not use this device to the place with
rain, sun light, heating devices, wet and dusty .
Otherwise, it will lead to accident.
5.
Please do not dismantle and modify the device.
6.
To avoid the electric shock, please do not handle
plug of this device or electric device using wet hand.
7.
Please do not leave device in the reach of children
avoid wound and electric shock.
8.
If some abnormal situation happens, please STOP
using this device immediately to avoid any accident.
