![background image](/i/rucelf/143420/rucelf-sdw-500/h/rucelf-sdw-500-038.png)
38
eng
11. Additional information
It’s important: Please read all instructions of this manual
Problem
Decision
The stabilizer doesn’t start
Check the connection to the
alternating circuit. Press the button
#7 (fig.2) Check the fuse #10 (fig.3)
The output voltage is different
The bypass mode is activated on the
automatic switch. Activate the mode
“Network”
The output voltage is less than 220 V.
The yellow indicator is active.
The voltage on the stabilizer is less
than 140 V. Call to the central
eclectic service.
The output voltage is more than
220 V. The red indicator is active.
The voltage on the stabilizer is more
than 220 V. Call to the central
eclectic service.
The stabilizer disconnect the output
load. The green indicator is active.
The stabilizer protection is active.
The critical voltage leap happened.
The stabilizer will started after
normalization of input voltage.
The stabilizer disconnect the output
load. The green, yellow and red
indicator is active
The temperature protection is
active. The load power is more than
normal. The stabilizer will started
after normalization of temperature
mode. Please, reduce the load power.
Ventilation holes are possibly closed.
The green, yellow and red indicator is
active after stabilizer starting.
The temperature sensor is defected.
Call to the service centre.