Инструкция для SAMSUNG AW126JB / 127JB

(скачивание инструкции бесплатно)
Формат файла: PDF
Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.
Дополнительно: Чтение инструкции онлайн
background image

Disassembly and Reassembly

4-4

Samsung Electronics

No.

Part name

Procedures

Remarks

Frame Up

Case Cond &
Propeller Fan

1. Remove 10 screws on the Frame Up.

1. Remove two screws on the bottom side,

and 5 screws on the case cond.

2. Remove the nut flange, and remove the

propellr fan

AW126JB-2  6/27/98 10:40 AM  Page 2

1
2
3
4
5
Оглавление инструкции
  • Страница 1 из 6
    AW126JB-1 6/27/98 10:38 AM Page 11 4. Disassembly and Reassembly 4-1 Compressor Replacement Flow Chart Locate cause of defect Release refrigerant Disconnect electrical wiring from compressor Cut refrigerant lines from compressor Plug disconnected lines Replace compressor Inspect electrical wiring
  • Страница 2 из 6
    AW126JB-1 6/27/98 10:38 AM Page 12 4-2 Checking the oil Fill the transparent container with 10cc of oil, and then conduct the test. 4-2-1 Oil quality Refrigerant Cycle Oil Condition Remarks Color Odor Normal Light Yellow No Odor Return with the system Over-heated Brown - Oil Change Compressor
  • Страница 3 из 6
    AW126JB-2 6/27/98 10:40 AM Page 1 4-3 Disassembly and Reassembly Procedure Stop operating the air conditioner, and pull out the power cord before repair. No. ① Part name Ass'y Grill Procedures Remarks 1. Pull the panel front and remove the screw on the grille °C Hour COOL FAN POWER / MODE 2. Hold
  • Страница 4 из 6
    AW126JB-2 6/27/98 10:40 AM Page 2 Disassembly and Reassembly No. Part name Procedures ➃ Frame Up 1. Remove 10 screws on the Frame Up. ➄ Case Cond & Propeller Fan 1. Remove two screws on the bottom side, and 5 screws on the case cond. Remarks 2. Remove the nut flange, and remove the propellr fan 4-4
  • Страница 5 из 6
    AW126JB-2 6/27/98 10:40 AM Page 3 Disassembly and Reassembly No. ➅ Part name Blower & Motor Procedures Remarks 1. Remove two screws on the clip motor, and remove the clip motor. 2. Move the motor & blower toward the evap, and lift up the motor & blower from the frame low. ➆ Cond Casing Samsung
  • Страница 6 из 6