![background image](/i/samsung/68974/samsung-np-r428-np-r428i/h/samsung-np-r428-np-r428i-022.png)
1-22
Connect and Disconnect
the AC adapter
The socket-outlet shall be installed near the
equipment and shall be easily accessible.
Do not unplug the power cord out by pulling
the cable only.
Power Cord Requirements
The power cord set (wall plug, cable and
AC adapter plug) you received with your
computer meets the requirements for use
in the country where you purchased your
equipment.
Power cord sets for use in other countries
must meet the requirements of the country
where you use the computer. For more
information on power cord set requirements,
contact your authorized dealer, reseller, or
service provider.
General Requirements
The requirements listed below are
applicable to all countries:
All power cord sets must be approved
by an acceptable accredited agency
responsible for evaluation in the country
where the power cord set will be used.
The power cord set must have a
minimum current capacity of 7 A and a
nominal voltage rating of 125 or 250 volts
AC, as required by each country’s power
system. (USA ONLY)
The appliance coupler must meet the
mechanical configuration of an EN 60
320/IEC 320 Standard Sheet C7 (or C5)
connector, for mating with appliance inlet
on the computer.